CP6的IO代码.pdf - 第278页
1.6 Loading W32 Paper Feeder (used only in Japan) 1.6.1 Loading Procedures 1. Release the lock by raising the tape leaf while pushing the clamp pins (one on the right side and one on the left side) at the same time. When…
8. Manually feed the part and check the pick-up position. To feed the part one pitch,
push the lever in the direction as shown. When the component pitch is P24 or P32,
it is necessary to feed 2 times. When the component pitch is P36, it is necessary to
feed 3 times.
Confirming Pick-up Position
9. Confirm that the part lines up with the pickup point shown below, after feeding
the part one pitch at a time. Use a pair of scissors to cut the tape that extends over
the end of the feeder.
Note: Tearing the tape by hand may cause feeding problems.
Confirming Pick-up Position
❈
❈
Pick-up point
CP6M8024
Tape feed lever
CP6M8023
Part 8 Chapter 1 WC Feeders
Edition 1.0 8-1-15 CP-6 Series Mechanical Reference
1.6 Loading W32 Paper Feeder (used only in Japan)
1.6.1 Loading Procedures
1. Release the lock by raising the tape leaf while pushing the clamp pins (one on the
right side and one on the left side) at the same time. When unlocked, the tape leaf
will raise up in the direction of the arrow (due to spring pressure).
Unlocking the Tape Leaf
Tape leaf
Spring
Clamp pin
CP6M8025
Part 8 Chapter 1 WC Feeders
Edition 1.0 8-1-16 CP-6 Series Mechanical Reference
2. Set the parts reel into the feeder holder. Set the components so that the parts feed
from the top of the reel as shown in the illustration. Make sure to use the center
pin in the holder.
Setting the Parts Reel 1
Note: Because the W32 paper feeders do not have rollers, make sure to use the center pin.
Parts reel
Parts tape
Holder
Pin
Groove
When loading components, insert
the pin into the center hole of the
parts reel, align the grooves on
the pin with the slots on the holder
and slide to the bottom-most point
of the holder.
CP6M8026
Part 8 Chapter 1 WC Feeders
Edition 1.0 8-1-17 CP-6 Series Mechanical Reference