CP6的IO代码.pdf - 第79页

2. Feeder Setting Point The feeder must be correctly set on the device table in order for parts to be accurately picked by the nozzles. Procedure W ARNING Always be sure to cut off the 200 V power before carrying out any…

Notes:

Part 2 Chapter 1 Changing the Conveyor Width

Edition 1.3 2-1-2 CP-6-series Mechanical Reference

2. Feeder Setting

Point

The feeder must be correctly set on the device table in order for parts to be accurately

picked by the nozzles.

Procedure

WARNING

Always be sure to cut off the 200 V power before carrying out any

work.

Check that the feeders are correctly set on the device table or the pallet (CP-652C) as

described below.

1. Ensure that no foreign matter (waste paper, dust, etc.) becomes sandwiched

between the feeders and the device table. Remove any foreign matter from the

device table and the bottom of the feeder before setting feeders.

2. Check for any tape leaf deformities.

Feeder

Foreign matter

Device table

CP6M2002

Part 2 Chapter 2 Feeder Setting

Edition 1.0 2-2-1 CP-6-Series Mechanical Reference

3. Use the appropriate feeder type according to part type.

Incompatible part tape makes it impossible to close the tape leaf correctly.

CP6M2003

Correct Incorrect

Part 2 Chapter 2 Feeder Setting

Edition 1.0 2-2-2 CP-6-Series Mechanical Reference