CP6的IO代码.pdf - 第282页

7. Return the tape leaf. Take-up the slack tape and confirm that the tape feed holes are aligned with the sprocket teeth. Push in the clamp pins (one on the right side and one on the left side) and slowly lower and lock …

5. Feed the adhesive tape through the rollers and wind the take-up reel as shown.

After feeding the adhesive tape through the rollers, rotate the take-up reel in the

direction of the arrow as shown. When the adhesive tape is wound too tight, it is

necessary to turn the take-up reel in the opposite direction. Because there is

resistance in the take-up reel axis, it is necessary to use a little force when rotating.

Setting the Adhesive Tape

6. Set the paper tape by aligning with the sprocket teeth. At this point, keep the pick-

up position in mind.

Setting the Parts Tape

Pickup point

CP6M8030

Take-up reel

Roller 2

Roller 1

Adhesive tape

CP6M8029

Part 8 Chapter 1 WC Feeders

Edition 1.0 8-1-19 CP-6 Series Mechanical Reference

7. Return the tape leaf. Take-up the slack tape and confirm that the tape feed holes

are aligned with the sprocket teeth. Push in the clamp pins (one on the right side

and one on the left side) and slowly lower and lock the tape leaf. Be careful to not

cut the adhesive tape or the paper tape. When the tape leaf is not set properly, the

spring will raise the tape leaf.

Setting the Tape Leaf

8. Manually feed the part and check the pick-up position. To feed the part one pitch,

push the lever in the direction as shown.

Confirming Pick-up Position

Tape feed lever

CP6M8032

Tape leaf

Spring

Parts tape

Clamp pin

CP6M8031

Part 8 Chapter 1 WC Feeders

Edition 1.0 8-1-20 CP-6 Series Mechanical Reference

9. Confirm that the part lines up with the pick-up point shown below after feeding

the part one pitch at a time. Use a pair of scissors to cut the tape that extends over

the end of the feeder.

Note: Tearing the tape by hand may cause feeding problems.

Confirming Pick-up Position

❈

Pickup point

CP6M8033

Part 8 Chapter 1 WC Feeders

Edition 1.0 8-1-21 CP-6 Series Mechanical Reference