CP6的IO代码.pdf - 第304页

1.1 1.2 T ake-up Reel Drive Adjustment This section covers only the W32 mm (paper) feeder. If the take-up of the adhesive parts tape is not acting normally, adjust the take-up reel drive force. It is possible to use any …

2. Replacing the spacer.

The spacer is not used in the A type feeders. When the spacer is inserted, the

feeder becomes the B type feeder.

Replacing the Spacer

Parts Compatibility Table

A type

B type

Lever

AWCE3401

AWCE3800

WCE0370

WCE0380

Sticker

Spacer

WCE0340

CP6M8064a

Guide

Spacer

CP6M8064

Part 8 Chapter 1 WC Feeders

Edition 1.0 8-1-41 CP-6 Series Mechanical Reference

1.11.2 Take-up Reel Drive Adjustment

This section covers only the W32 mm (paper) feeder.

If the take-up of the adhesive parts tape is not acting normally, adjust the take-up reel

drive force.

It is possible to use any one of three spring hook positions, allowing three different

settings for drive force.

Note : If the drive force is too weak, use the hook hole on the outside of the take-up lever.

Changing the Position of the Spring for the Adhesive Tape Take-up Reel

Spring

Take-up lever

Hook hole

CP6M8065

Part 8 Chapter 1 WC Feeders

Edition 1.0 8-1-42 CP-6 Series Mechanical Reference

1.12 Feeder Jigs

Use the following jigs to assist in feeder handling.

Feeder Jigs

• Using the Feeder Remover Jig

This jig is used when setting a feeder or removing a feeder from the device table.

Using the Feeder Remover Jig

CP6M8067

Feeder remover

(Drawing # : WPJ 0780)

7-inch reel remover

(Drawing # : AWPJ 8040)

For 7-inch

For 13-inch

CP6M8066

Part 8 Chapter 1 WC Feeders

Edition 1.0 8-1-43 CP-6 Series Mechanical Reference