CP6的IO代码.pdf - 第322页

C-2 Is the sprocket stop position stable? Measure in the same way as C-1. C-3 Is the part (parts tape) set as per the nozzle and tape leaf specification? When the parts tape is set into the feeder, check that it is in ac…

B-4 Is the ratchet (sprocket) advancing correctly for the tape feed stroke (8 mm)?

Set the feeder on the D-shaft table and move it to the pick-up point. Use I/O to

remove the 1st stopper, and set the cam shaft to 183˚ to 237˚ with the inching key

(on the CP-65, set to 184˚ to 235˚).

Check that the required feed operation is executing normally.

Checking the Ratchet Movement

B-5 Try Changing the Tape Feed Spring Force

Refer to section 2.1 “Disassembling the Feeder” of Chapter 2 of this part for details

on changing the tape feed spring.

C Low pick-up ratio, but not accompanied by the above

C-1 Is the part pick-up point offset?

Use an inspection instrument to measure the sprocket stop position.

Inspection instrument : DT-551 Feeder Pick-up Position

Check Unit

For details, refer to the DT-551 operation manual.

203 mm

8 mm (Stroke)

CP6M8088

Part 8 Chapter 3 Troubleshooting

Edition 1.0 8-3-5 CP-6 Series Mechanical Reference

C-2 Is the sprocket stop position stable?

Measure in the same way as C-1.

C-3 Is the part (parts tape) set as per the nozzle and tape leaf specification?

When the parts tape is set into the feeder, check that it is in accordance with nozzle

and tape leaf specifications.

Refer to section 1.9 “Selecting a Tape Leaf” of Chapter 1 of this part for details.

C-4 Is the tape leaf deformed?

Use a flatness measurement tool to make sure the W8 mm tape feeder tape leaf is

free of warping and twisting.

Flatness measurement tool W8 x P2 : Z9913AWPJ9540

W8 x P4 : Z9913AWPJ9550

For shutter-type tape leaf units, stand the tape leaf vertically and verify that the

shutter drops under its own weight (simple test). Also check that there is no

looseness in the shutter, and no deformation in the U-slot.

Checking the Shutter Type Tape Leaf

CP6M8089

Part 8 Chapter 3 Troubleshooting

Edition 1.0 8-3-6 CP-6 Series Mechanical Reference

4. Loading Feeders into the Feeder Rack

When loading the feeder into the feeder rack, make sure to observe the following points.

1. Confirm that the tape leaf is locked.

Confirming Locked Tape Leaf

Note: Lock the tape leaf using the tape leaf lock or the clamp pin.

2. Carefully set the feeder into the feeder rack and gently slide to the front of the

feeder slot.

Setting Feeder into Feeder Rack

Feeder Rack

CP6M8091

Tape leaf

Tape leaf lock

Clamp pin

CP6M8090

Part 8 Chapter 4 Loading Feeders into Feeder Rack

Edition 1.0 8-4-1 CP-6 Series Mechanical Reference