CP6的IO代码.pdf - 第312页
8. Remove the flush screws that fix the bracket and then remove the bracket. On the bracket, there are 2 extruded studs pressed in to the main feeder body that are used for positioning. Be careful not to damage these stu…
6. Replace the sprocket. Be careful not to lose the 2 thin washers that are located on
each side of the sprocket.
Caution : Take care not to misplace the spacer.
When removing the sprocket, be sure not to bend the link.
Replacing the Sprocket
7. Remove the lever position pin and the joint pin. When the nuts are loosened, the
pin can be removed.
Removing the Link Assembly
Joint pin
Link Assembly
Nut
Lever position pin
CP6M8076
Spacer
Link
Sprocket
CP6M8075
Part 8 Chapter 2 Feeder Maintenance
Edition 1.0 8-2-3 CP-6 Series Mechanical Reference
8. Remove the flush screws that fix the bracket and then remove the bracket. On the
bracket, there are 2 extruded studs pressed in to the main feeder body that are
used for positioning. Be careful not to damage these studs. Use a flat driver or
other type of tool in removing the bracket. Take care not to damage the bracket or
scar the feeder. Also take care not to lose the collar that is between the bracket and
the feeder body.
Removing the Bracket
9. Replace the link assembly.
Replacing the Feed Jaw Spring
10. Replace the feed jaw spring.
Follow these procedures in reverse to assemble.
Feeding jaw spring
Link assembly
CP6M8078
Extruded studs
Collar
Link assembly
Bracket
Flush screw
Extruded studs
CP6M8077
Part 8 Chapter 2 Feeder Maintenance
Edition 1.0 8-2-4 CP-6 Series Mechanical Reference
2.2 Film Take-up Reel Reverse Torque Check
(WC and MC Types)
If the top film take-up reel reverse torque is weak, the top film may not be taken up
normally.
Use a push-pull gauge to confirm the reverse torque is set normally (1 kgf), and if it is
under this amount replace the reel.
Push-pull gauge
1. Set the push-pull gauge onto the periphery of the top film take-up reel.
2. Press the gauge to the blue mark (1 kgf), and verify that the top film take-up reel
does not rotate.
If it does rotate, replace the top film take-up reel.
Film Take-up Reel Reverse Torque Check
Top film take-up reel
Take-up lever
Feed lever
1 kgf
mark
Caution : The take-up lever and the feed
lever should make contact with
each other during measurement.
CP6M8080
Z9064ALPJ5560
Push-pull gauge
CP6M8079
Part 8 Chapter 2 Feeder Maintenance
Edition 1.0 8-2-5 CP-6 Series Mechanical Reference