P-TOOL说明书.pdf - 第67页

2-33 2 Board Explorer ● Lead par ts Whenaboarddataofmounterincludeleadpartsasbelow,theconvertedinspectiondatahas,foreachparts,1stepfor bodyinspectionand1stepforeachleadsidetocheckleads. S…

100%1 / 228
2-32
2
Board Explorer
l
Chip Parts
When a board data of mounter includes chip parts as below, and executes conversion, for each mount position of the
parts, this conversion set 1 step for parts body inspection and 2 steps for solder inspection.
X (mm)
Y (mm)
Chip Parts
63200-S0-00
Parts body inspection step
Solder inspection step
X / 3 X X / 3
Y + 0.2mm
Y * 1.1
VADMIC inspection data of chip parts
63205-S0-00
But when the parts size is over 10mm, the Y size of parts body inspection step is set to Y size +1.0mm.
Each steps size is set as above picture.
2-33
2
Board Explorer
●
Lead parts
Whenaboarddataofmounterincludeleadpartsasbelow,theconvertedinspectiondatahas,foreachparts,1stepfor
bodyinspectionand1stepforeachleadsidetocheckleads.
Soifapartshasleadsforall4sides,theconvertedinspectiondatahas1bodyinspectionstepand4leadinspection
steps,total5steps.
Reflect lead length S mm
Lead pitch U mmLead width T mm
X (mm)
Y (mm)
Lead parts
63201-S0-00
Parts body inspection step
Lead inspection step
Y−S
S * 2.5
(V-1) * U + T + 0.2
S/2
S * 1.25
(Y−S) * 0.05
X * 0.05
X
X * 0.05
VADMIC inspection data of lead parts
63202-S0-00
Theinspectionstepsforbodyinspectionareonlysettonoleadsizeasenlargedthesize0.05times(maximum0.5mm).
But, for the special lead parts, it is set as below “Other parts”.
2-34
2
Board Explorer
l
Other parts
For the other parts as BGA, inspection step is set 1.1 times bigger than the parts size (maximum margin is 0..5mm for
each side) as below.
X (mm)
Y (mm)
Other parts ( except chip and lead parts)
63203-S0-00
Y *1.1
X *1.1
VADMIC inspection data of other parts
63204-S0-00
For each inspection step, by the data conversion, the default data is set as below.
•InspectionStatus :VADMIC
•ReferenceNumber :Patternnameofmounterboarddata
•PartsName :Partsnameofmounterboarddata
•Lib-partsName :Partsnamewhichissetinthepartsshapetable
•MountblockNo :Blocknumberofmounterboarddata
•Angle :Mountangleofmounterboarddata
•MinimumSizeX,Y:12(bodyinspection),6(solderorleadinspection)
•MinimumArea :25
•MatchingRatio :30
•DivideNumberX :PartsbodysizeX/300μm
•DivideNumberY :PartsbodysizeY/300μm
•LightingType :M(bodyinspection),
L-U(solderinspection),
BR2(leadinspection)