KY8030 Programmers Manual.pdf - 第74页

72 | KY-8030 Series (KYOS-2007001_rev0) 3D  In ‐ line  Solder  Paste  Inspection  Systems  7) Search ID Compare a pad file with a CA D file to find any inconsistency. * ALL: Check all pads. * NotFind: Check pads th…

Programmers Manual

| 71

Mouse mode

Select a desired mouse mode from the

following:

* Pad: Select a pad.

* Fiducial: Select a fiducial.

* Unused: Select a pad which will not be

inspected.

* CAD Move: Move a CAD position.

Pad Search

Search for a pad with a pad ID or component

ID.

Unselect All

Unselect all selected pads.

Select

Select a pad that meets a search condition as

follows:

* Same Pads:

Select all pads that have the same shape as

the selected pad.

* Same Parts:

Select all pads within the part to which the

selected pad belongs.

* Same Stencil:

Select all pads within the stencil to which the

selected pad belongs.

* Reverse:

Select the unselected pads and unselect the

selected pads.

Unused

Set the state of a pad to “unused” or set the

"unused" pad state back to “normal”.

72 | KY-8030 Series(KYOS-2007001_rev0)

3DIn‐lineSolderPasteInspectionSystems

Search ID

Compare a pad file with a CAD file to find any

inconsistency.

* ALL: Check all pads.

* NotFind:

Check pads that do not match the CAD.

The All button works via the component ID

frame interface in 5.1.7 4). After modifying

the component ID, make sure to press the All

button to apply changes.

Array

When using an array board, select all arrays or a

certain array number.

2.1.6. Status Bar

The status bar at the bottom of the screen shows the number of pads, positions of pads

and the file name.

Coordinate: Shows a variety of information on the selected pad.

Selected Pads: Shows the number of pads.

File Name & Total Pads : Shows a file name and the number of

pads.

2.1.7. Left Job Panel

1) Pad

Display information on the selected pad.

Pad Information: ID, board array, panel, Component ID, type, X-position, Y-position,

size X, size Y and area.

2) Inspection Conditions

Display inspection conditions for a pad.

You can edit these conditions by clicking the Edit button.

※ Note: For more information on specifying inspection conditions, see “6.3.3 6) Edit Job File”.

Programmers Manual

| 73

3) Coplanarity

Check uniformity of the pad heights in a component.

① With your mouse, specify the area for which you want to check coplanarity.

② After selecting Coplanarity, enter the upper/lower limits for the difference in heights.

③ Enter a name and click the ADD button. A new item will be registered in the following list

box.

④ Select Exec to perform inspection for the corresponding group.

4) Component ID

Display a component ID.

You can modify/edit/search for a Component ID by clicking the Modify/Edit/Find

button, respectively.

① Click the Pin button to display the pin number for the corresponding component.

② Click the CAD Refresh button to display the Component ID and contour lines.

③ Click the Modify button to move the CAD location of the selected component or to

adjust the order in which pin numbers are assigned.

④ Click the Edit button to change the settings for the library linked with the

corresponding component.