4OM-1322-006_w.pdf - 第79页
1-20 AKOEMT -ID 3.3.3 Screen Holder Section Screen Printing Pattern Every Day Cleaning After using the screen, use an ultrasonic cleaner (industrial alcohol solvent) to clean the screen such that the mesh (pores) of the …
1-19 AKOEMT-ID
Screen Recognition X-Axis
Linear Guide
Every Month Cleaning
Clean the stopper with an oiled rag.
Do not leave any waste
threads after cleaning.
Note
Screen Recognition X-Axis
Linear Guide
Every 6 Months Lubrication
Apply grease with a brush or a
spatula.
Screen Recognition X-Axis
Ball Screw
Every 6 Months Lubrication
Apply grease with a brush or a
spatula.
If a large amount of grease is
applied, it may be dispersed
over a PCB and the screen.
After applying grease, brush
the surface or scrape with a
spatula until a small amount
of grease remains on the
surface of the ball screw.
Note
Fig. 4A11
Guide Bushing for Squeegee
Up/Down Movement
Every Month Cleaning
Clean the stopper with an oiled
rag.
Do not leave any waste
threads after cleaning.
Guide Bushing for Squeegee
Up/Down Movement
Every 6 Months Lubrication
Apply grease with a brush or a
spatula.
Fig. 4A12
0609-002
3.3 Inspection, Cleaning, and Lubrication Spots
1-20 AKOEMT-ID
3.3.3 Screen Holder Section
Screen Printing Pattern
Every Day Cleaning
After using the screen, use an
ultrasonic cleaner (industrial
alcohol solvent) to clean the screen
such that the mesh (pores) of the
screen (screen patterns) is not
clogged.
Clean the lower surface of the
screen with a rag soaked in
industrial alcohol (solvent).
Upper Surface of Screen Holder
Every Day Cleaning
Wipe off dirt and dust accumulated
on the upper and side surfaces
with a rag.
Lower Surface of Screen
Every Day Cleaning
Fig. 4A13
Screen Y-Axis Ball Screw
Every 6 months Lubrication
Apply grease with a brush.
If a large amount of grease is
applied, it may be dispersed
over a PCB and the screen.
After applying grease, brush
the surface or scrape with a
spatula until a small amount
of grease remains on the
surface of the ball screw.
Note
Fig. 4A14
0609-002
3.3 Inspection, Cleaning, and Lubrication Spots
1-21 AKOEMT-ID
Note
Note
Note
Screen Y-Axis Linear Guide
Every Month Cleaning
Clean the stopper with an oiled
rag.
Do not leave any waste
threads after cleaning.
Screen Y-Axis Linear Guide
(Rear Side)
Every 6 Months Cleaning
Inject new grease from the grease
nipple with a grease gun or a brush.
The used attachments should
be the U- and P-types or the
SPK-3C.
Screen Y-Axis Linear Guide
(Front Side)
Every 6 Months Cleaning
Inject new grease from the grease
nipple with a grease gun or a brush.
The used attachments should
be the U- and P-types or the
SPK-3C.
Fig. 4A15
0609-002
3.3 Inspection, Cleaning, and Lubrication Spots