4OM-1322-006_w.pdf - 第91页

1-32 AKOEMT -ID T able � -Axis Movable Bearing Outer Circumference Every 3 Months after Initial One Lubrication (NM1) Apply grease with a brush or a spatula. T abel � -Axis Linear Guide Every Month Cleaning Clean the sto…

100%1 / 211
1-31 AKOEMT-ID
Table Z-Axis Guide Bushing
Every Month Cleaning
Clean the stopper with an oiled rag.
Do not leave any waste
threads after cleaning.
Note
Table Z-Axis Guide Bushing
Every 6 Months Lubrication
(1) Move the table Z axis up to
the printing position.
(2) Detach the cover located in
front of the table.
(3) Apply grease to the X-axis
ball screw with a brush or a
spatula.
Table Z-Axis Ball Screw
Every 6 Months Lubrication
(1) Move the table Z axis up to
the printing position.
(2) Detach the cover located in
front of the table.
(3) Apply grease to the X-axis
ball screw with a brush or a
spatula.
Fig. 4A29
0609-002
3.3 Inspection, Cleaning, and Lubrication Spots
1-32 AKOEMT-ID
Table �-Axis Movable Bearing
Outer Circumference
Every 3 Months after Initial One
Lubrication (NM1)
Apply grease with a brush or a
spatula.
T
abel �-Axis Linear Guide
Every Month Cleaning
Clean the stopper with an oiled rag.
Do not leave any waste
threads after cleaning.
Note
Tabel �-Axis Ball Screw
Every 6 Months Lubrication
Apply grease with a brush or a
spatula.
Fig. 4A30
Tabel �-Axis Linear Guide
Every 6 Months Lubrication
Inject new grease from the
grease nipple with a grease gun
from the rear side of the machine.
Use the H-type attachment.
Note
Fig. 4A31
0609-002
3.3 Inspection, Cleaning, and Lubrication Spots
1-33 AKOEMT-ID
Note
Table X-Axis Linear Guide
(Front Left Side)
Every 6 Months Lubrication
Inject new grease from the grease
nipple with a brush or a grease
gun.
Use the U- and P-type
attachments.
Note
Table X-Axis Linear Guide
(Front Right Side)
Every 6 Months Lubrication
Inject new grease from the grease
nipple with a brush or a grease
gun.
Use the U- and P-type
attachments.
Fig. 4A32
Note
Table X-Axis Linear Guide
(Rear Side)
Every 6 Months Lubrication
Inject new grease from the grease
nipple with a brush or a grease
gun.
Use SPK-3C attachment.
Fig. 4A33
0609-002
3.3 Inspection, Cleaning, and Lubrication Spots