4OM-1322-006_w.pdf - 第82页
1-23 AKOEMT -ID Note Note Note PEC Recognition Y -Axis Linear Guide (Front Right Side) Every 6 Months Lubrication Inject new grease from the grease nipple with a brush or a grease gun. Use the H-type attachment. PEC Reco…
1-22 AKOEMT-ID
3.3.4 PEC Recognition Section
Remove dirt and dust with an ari
blow brush for camera.
Camera (Lens)
PEC Recognition Lighting Glass
Surface
Every Month Cleaning
PCB Warpage Top Holder
(Outer Circumference of Roller)
Every Week Cleaning
Wipe off dirt and dust
accumulated on the outer
circumference of the roller with
a rag.
PCB Stopper
Every Week Cleaning
Clean the stopper with an oiled
rag.
Do not leave any waste
threads after cleaning.
Note
PEC Recognition
X-Axis Linear Guide
Every Month Cleaning
Clean the stopper with an oiled
rag.
Do not leave any waste
threads after cleaning.
PEC Recognition
X-Axis Linear Guide
Every 6 Months Lubrication
Apply grease with a brush or a
spatula.
Note
Note
PCB Stopper Guide Bushing
Every 6 Months Lubrication
Apply grease with a brush or a
spatula.
Apply grease to the surface
of the shaft thinly.
Fig. 4A16
0609-002
3.3 Inspection, Cleaning, and Lubrication Spots
1-23 AKOEMT-ID
Note
Note
Note
PEC Recognition Y-Axis
Linear Guide (Front Right Side)
Every 6 Months Lubrication
Inject new grease from the grease
nipple with a brush or a grease
gun.
Use the H-type attachment.
PEC Recognition Y-Axis
Linear Guide (Front Left Side)
Every 6 Months Lubrication
Inject new grease from the grease
nipple with a brush or a grease
gun.
Use the H-type attachment.
PEC Recognition
Y-Axis Linear Guide
Every Month Cleaning
Clean the stopper with an oiled
rag.
Do not leave any waste
threads after cleaning.
Fig. 4A17
0609-002
3.3 Inspection, Cleaning, and Lubrication Spots
1-24 AKOEMT-ID
PEC Recognition
Y-Axis Ball Screw
Every 6 Months Lubrication
Apply grease with a brush or a
spatula.
If a large amount of grease is
applied, it may be dispersed
over a PCB and the screen.
After applying grease, brush
the surface or scrape with a
spatula until a small amount
of grease remains on the
surface of the ball screw.
Note
PEC Recognition
Y-Axis Linear Guide
Every Month Cleaning
Clean the stopper with an oiled
rag.
Do not leave any waste
threads after cleaning.
Note
Note
PEC Recognition
Y-Axis Linear Guide (Rear Side)
Every 6 Months Lubrication
Inject new grease from the grease
nipple with a brush or a grease
gun.
Use the H-type attachment.
PEC Recognition
X-Axis Ball Screw
Every 6 Months Lubrication
Apply grease with a brush or a
spatula.
If a large amount of grease is
applied, it may be dispersed
over a PCB and the screen.
After applying grease, brush
the surface or scrape with a
spatula until a small amount
of grease remains on the
surface of the ball screw.
Note
Fig. 4A18
0609-002
3.3 Inspection, Cleaning, and Lubrication Spots