00192405-02.pdf - 第148页
4 Component handling User Manual SIPLACE S-25 HM 4.7 Matrix tray changer Software Version SR.502.xx 01/2001 US Edition 148 4.7.6 Safety instructions for coupling and uncoupli ng the matrix tray changer 4 Fig. 4.7 - 3 Saf…
User Manual SIPLACE S-25 HM 4 Component handling
Software Version SR.502.xx 01/2001 US Edition 4.7 Matrix tray changer
147
4.7.4.2 Electrical ratings
4
4.7.4.3 Noise emissions
4
4.7.4.4 Permissible ambient factors
4
4.7.5 Operation, maintenance, service
The manuals supplied with the MTC contain extensive documentation on how to operate,
maintain and service the MTC. 4
4
Supply voltage 3 x 400 V, 50 Hz (Europe)
3 x 208 V, 60 Hz (USA)
Total power 3.5 kW
Rated current 2.7 A @ 3 x 400 VAC
4.2 A @ 3 x 208 VAC
Fuse 3 x 16 A
Rated current consumption of largest consumer 2 A
Maximum noise generation 80 dB (A)
Room temperature Between 15 °C and 35 °C
Atmospheric humidity 30 - 75%
(but no higher than 45% on average in order to prevent
any possibility of condensation on the machine).
4 Component handling User Manual SIPLACE S-25 HM
4.7 Matrix tray changer Software Version SR.502.xx 01/2001 US Edition
148
4.7.6 Safety instructions for coupling and uncoupling the matrix tray changer
4
Fig. 4.7 - 3 Safety instructions for coupling and uncoupling the MTC
(1) Gap when the MTC is coupled
(2) MTC control cable
(3) Control cable for component feeder table
(4) Power supply connection
User Manual SIPLACE S-25 HM 4 Component handling
Software Version SR.502.xx 01/2001 US Edition 4.7 Matrix tray changer
149
WARNING 4
Å NEVER place your hand in the gaps between the MTC and machine frame (item 1) while
the machine is running.
Å Always couple the MTC to the machine before connecting or disconnecting the MTC control
cable at the machine socket (item 2).
Å Always couple the MTC to the machine before connecting or disconnecting the control
cable for the MTC’s integral component feeder table at the machine socket (item 3).
Å Always couple the MTC to the machine before connecting or disconnecting the power cable
from the external power supply (item 4).
Å NEVER operate the MTC if it is not coupled to the machine.