Pneumatic Tape Feeder _ENG Ver9_.pdf - 第35页
Operation of the T ape Feeder 2-1 1 Figur e 2-19. Replacing a lar ge r eel (8mm Non-St op tape feeder) T ake-up reel plate Large reel arm plate Standard reel arm plate Reel hange r Guide plate
Samsung Pneumatic Tape Feeder Users' Manual
2-10
Figure 2-17. Composition of the tape
Strip off about 30cm of the upper cover tape from the end, and pass it through the tape slit
as shown in the figure below.
Figure 2-18. Exit of the upper cover tape
Caution
If the distance from the end of the carrier tape to the pickup
position is too short, the tape may get caught or other
problems may occur. Ensure that this distance is sufficient
in length.
Top cover tape
Carrier tape
Bottom cover tape
Tape separation slit
Tape guide
Upper cover tape
Cover tape
Upper cover tape
Operation of the Tape Feeder
2-11
Figure 2-19. Replacing a large reel (8mm Non-Stop tape feeder)
Take-up reel plate
Large reel arm plate
Standard reel arm plate
Reel
hange
r
Guide plate
Samsung Pneumatic Tape Feeder Users' Manual
2-12
Pass the carrier tape through groove C.
Figure 2-20. Exit of the carrier tape of the 8mm tape feeder
Figure 2-21. Exit of the carrier tape of the 12-56mm tape feeder
Insert the sprocket into the transport groove of the carrier tape, press the tape guide and
shut the locker. When the lock cover is shut properly, the buck-up is released
automatically. Verify that the carrier tape is tightly attached to the tape guide and the
buck-up.
Tape
Groove C
Tape reel
Tape
Groove C