Pneumatic Tape Feeder _ENG Ver9_.pdf - 第58页
Samsung Pneumatic T ape Feeder Users' Manual 2-34 Figur e 2-56. Inserting/Installing on the feeder base of the 0603 di sposal type tape feeder
Operation of the Tape Feeder
2-33
Figure 2-54. Installing the feeder base of the 8mm Non-Stop tape feeder
Figure 2-55. Inserting/Installing on the feeder base of the 12-56mm tape feeders
The appearance of the 0603 Disposal Type Feeder is similar to other general disposal type
feeders, but its clamping method is distinctive. Therefore, press it with care before
mounting. For the 0603 disposal type tape feeder, after releasing the clamp arm,
press it once more toward the equipment direction until it reaches the stopper.
Clamp arm
Samsung Pneumatic Tape Feeder Users' Manual
2-34
Figure 2-56. Inserting/Installing on the feeder base of the 0603 disposal type tape feeder
Maintenance
3-1
Chapter 3. Maintenance
3.1. Maintenance of the Tape Feeder
3.1.1. Lubrication and removing foreign matter
Mechanically moving parts are fully lubricated before shipment. However, because of
continuous movements, the duration of fully lubricated condition of the following parts is
short. Since these parts play an important role in tape feeder movement, they should be
checked regularly and kept well lubricated.
3.1.1.1. Shutter area
Remove foreign matter (chip) and apply the lubricant on the surface of the shutter
touching the tape guide so that it moves back and forth smoothly.
Caution
Repair and maintenance need to be done in a clean and safe
place.
If the feeder is handled with excessive force, the feeder could
be damaged.
Pay attention to safety and try not to damage or lose
components.
Be careful so that fingers don’t get stuck during maintenance.
Caution
It is positively necessary that these areas (Shutter, Rachet,
Take-up Reel and Sprocket) are cleaned (Removing foreign
matter) and lubricated.
And Occasionally check if there is foreign matter.
Especially for 0603 feeders, the check should be carried out
with care because the supplied chip is too small to be found
easily by vision.
Caution
Keep the end area of shutter guiding component from being
stuck grease.