Pneumatic Tape Feeder _ENG Ver9_.pdf - 第53页
Operation of the T ape Feeder 2-29 Figur e 2-48. Adjusting t he positi ons of the r ewind spring and the dr ain pawl spri ng of the N ST -08 Non-S top tape feeder (winding type) 2.2.5. Adjusting the location of 12~56mmta…
Samsung Pneumatic Tape Feeder Users' Manual
2-28
Figure 2-46. Pitch setup for the 12mm Non-Stop Tape Feeder
2.2.4. Adjusting the position of the 8mm Non-Stop tape feeder (NST-08P4,
NST08E-4P) spring
The NST-08P4 Non-Stop Tape Feeder and the NST08E-4P Non-Stop Emboss Tape
Feeder use disposal type or winding type tape depending on the tape specification. The
position of the rewind spring and the drain pawl spring shall be adjusted accordingly.
However, using both the disposal type and winding type by adjusting the position of the
spring is applied to NST-08 only.
Figure 2-47. Adjusting the positions of the rewind spring and the drain pawl spring of the NST-08
Non-Stop tape feeder (disposal type)
Drain pawl spring
Rewind spring
Operation of the Tape Feeder
2-29
Figure 2-48. Adjusting the positions of the rewind spring and the drain pawl spring of the NST-08
Non-Stop tape feeder (winding type)
2.2.5. Adjusting the location of 12~56mmtape feeder Rewind Spring
Adjust the position of the rewind spring according to the condition of component supply.
12mm 16mm 24-44mm 56mm
Figure 2-49. Adjusting the location of 12~56mmtape feeder Rewind Spring
The normal position of locking up the spring as a base, the force of removing the vinyl
can be increased by moving the position to (+) direction and it can be decreased by
moving it to (-) direction.
If the height of a component is high, hook the spring on the pin in the (+) direction to
increase the force needed to strip off the vinyl sheet. If the height of a component is low
Normal
(
-
)
Normal
(
+
)
(
-
)
Normal
(
-
)
(
+
)
(
-
)
Normal
Drain pawl spring
Rewind spring
Samsung Pneumatic Tape Feeder Users' Manual
2-30
or if the component is lightweight or has a long transfer pitch, hook the spring on the pin
in the (-) direction to decrease the force needed to strip off the vinyl sheet.
2.2.6. Rewind Spring Position Adjustment for 12mm-16mm Non-Stop Tape
Feeder
Adjust the position of the rewinding spring according to the component supply state
before using the tape feeder.
Figure 2-50. Rewind spring position adjustment of the 12mm-16mm tape feeder
The spring is principally hung at the normal position. The vinyl tape stripping force may
be increased or decreased by hanging it at the ( + ) or ( - ) position respectively as
required.
2.2.7. Rewind Spring Position Adjustment for 24mm-56mm Non-Stop Tape
Feeder
Adjust the position of the rewinding spring according to the component supply state
before using the tape feeder.
Caution
After changing the pitch, check manually if the pitch is set as
desired before mounting and using.
When changing the pitch, if screws are not tightened firmly,
loose screws might cause malfunction. Be sure to tighten the
screws firmly when changing the pitch.
(+)
(-)
N
ormal