Pneumatic Tape Feeder _ENG Ver9_.pdf - 第48页

Samsung Pneumatic T ape Feeder Users' Manual 2-24 Figur e 2-40. Setting the pickup position of the 8mm tape f eeder Figur e 2-41. Setting the pickup position of the 8mm tape f eeder Manual leve r Manual leve r

Operation of the Tape Feeder

2-23

For 12-56mm tape feeder, mount the upper cover tape coming out of the tape separation

slit on the take up reel while wrapped around the roller.

Figure 2-39. Mounting the upper cover tape of the 12-56mm tape feeder

Caution

When the shutter is opened, repeat pressing and releasing

the manual lever until the component (chip) is visible. At this

time, verify that the upper cover tape is not rolled under the

tape guide and the component is accurately placed on the

pickup position. If the part position is about 1/2 pitch off,

advance the part for 1/2 pitch by pressing the manual lever

lightly.

Upper cover tape

Rolle

Take up reel

Samsung Pneumatic Tape Feeder Users' Manual

2-24

Figure 2-40. Setting the pickup position of the 8mm tape feeder

Figure 2-41. Setting the pickup position of the 8mm tape feeder

Manual leve

Operation of the Tape Feeder

2-25

2.2. Changing the Transport Pitch

2.2.1. Changing the pitch of the 12mm tape feeder

For the 12mm tape feeder, either 4mm or 8mm pitch can be used depending on the

component types. The transport method can be set while adjusting the two screws as

shown in the figure below.

Figure 2-42. Setting 8mm pitch for the 12mm tape feeder

2.2.2. Pitch Change of 12/16mm Non-Stop Tape Feeder

In the case of the 12/16mm tape feeder, the transfer pitch can be changed to 4mm, 8mm

and 12mm depending on the component type. Set the transfer pitch by adjusting it with a

screw as shown below.

8mm pitch

4mm pitch