DECAN_S2_Trouble(Eng_Ver4.2).pdf - 第126页

1-104 Advanced Chip Shooter DECAN S2 T roubleshooting Guide  Check if the sup plied pneumatic pressure is as high as the set pressure (0.45 ~ 0.55 MPa) by the air pressure gauge through air panel on the front side of th…

1-103

System Messages of the MMI and Solutions

$6021 Since a part is picked up by the head spindle nozzle, it is not possible to return the

nozzle to the ANC. [EMER LEVEL]

[Problem]

 A part is picked up by the nozzle when returning the head spindle nozzle to the ANC.

[Solution]

 Turn off the Buzzer by pressing the “STOP” button.

 Press the “RESET” button to change the operation mode to “IDLE”.

 Check whether a part is picked up by the head spindle nozzle.

 Select the ‘Device’ submenu of the ‘System Setup’ menu and select the ‘Nozzle’ item.

Then check the ‘Check Vacuum’ value in the ‘Nozzle’ dialog box.

1-104

Advanced Chip Shooter DECAN S2 Troubleshooting Guide

 Check if the supplied pneumatic pressure is as high as the set pressure (0.45 ~ 0.55

MPa) by the air pressure gauge through air panel on the front side of the machine.

1: Pressure Decrease (Counterclockwise)

2: Pressure increase (Clockwise)

$6030 Nozzle in the head. Can't put. [FREEZE LEVEL]

[Problem]

 Following the nozzle ‘PUT’ operation, if the ANC hole center is not aligned, the

nozzle put operation is performed due to inadequate height setup, or the nozzle

actually mounted on the head, etc.

[Solution]

 Turn off the Buzzer by pressing the “STOP” button.

 Switch the machine to “IDLE” mode by pressing the “RESET” button.

 Press the “READY” button to supply power to the machine.

 After clicking the ‘Fiducial Mark Detail…’ on the ANC dialog box, move to the

fiducial mark to check if the fiducial mark position is properly setup. If not, perform

teaching again. For details on teaching, please refer to “6.3 Fiducial Mark Setup” in

the “Administrator’s Guide”.

1-105

System Messages of the MMI and Solutions

 First, execute the “Position” dialog box by clicking the button. After clicking

the ‘Hole Position Detail …’ in the ANC menu, select the error occurred ANC hole to

verify if the coordinates of the hole are correct and check if the selected device to be

moved is selected as “FidCam”. Then check if the hole center matches with the setup

position by clicking the <Move> button to move to the corresponding ANC hole.

Also, check if the set Z value of the ANC hole coordinate is accurate by moving down

the Z-axis manually using the teaching box.