DECAN_S2_Trouble(Eng_Ver4.2).pdf - 第93页
1-71 System Messages of the MMI and Solutions Warning Please check the movement of the se nsor and cylinder in the ‘Diagnosis I/O’ of MMI. As it is dangerous to check the sensor during the operation of the equipment, be …
1-70
Advanced Chip Shooter DECAN S2 Troubleshooting Guide
1.5t ~ 4t = 2.0kg / cm
2
(0.2Mpa)
Check if the solenoid related to the corresponding edge fixer works normally.
Check the wiring of the sensor related to the upward or downward movement of the
corresponding edge fixer.
For further details, refer to section “Axis Sensor Board Interface (1/2)” in the
Technical Reference.
1-71
System Messages of the MMI and Solutions
Warning Please check the movement of the sensor and cylinder in
the ‘Diagnosis I/O’ of MMI.
As it is dangerous to check the sensor during the operation
of the equipment, be sure to check the equipment in stop
status (idle mode) after releasing “Ready”.
$3049 Failed to turn the edge fixer on. [EMER LEVEL]
[Problem]
The edge fixer does not turn on normally.
[Solution]
Take measures same as those against the error code "$3048”.
$304a Failed to turn the edge fixer off. [EMER LEVEL]
[Problem]
The edge fixer does not turn off normally..
[Solution]
Take measures same as those against the error code "$3048”.
$304e An error occurred to the belt controller. [EMER LEVEL]
[Problem]
The conveyor belt does not run normally.
[Solution]
Turn off the Buzzer by pressing the “STOP” button.
Switch the machine to “IDLE” mode by pressing the “RESET” button.
Supply power to the motor of the machine by pressing the “READY” button.
Drive the belt again.
$304f There is no response from the belt controller. [EMER LEVEL]
[Problem]
The conveyor belt does not run normally.
[Solution]
Take measures same as those against the error code "$304e”.
Check the state of the corresponding step control board and driver
1-72
Advanced Chip Shooter DECAN S2 Troubleshooting Guide
$3055 Attempt was made to turn the belt while already turning. [EMER LEVEL]
$3059 An error occurred to the rail axis controller. [EMER LEVEL]
[Problem]
A command that moves the conveyor was transmitted to the step control board, but an
error occurred.
[Solution]
Turn off the Buzzer by pressing the “STOP” button.
Switch the machine to “IDLE” mode by pressing the “RESET” button.
Check the state of the corresponding step control board and driver.
$305b Exceeded the conveyor width movement range. [EMER LEVEL]
[Problem]
Attempt was made to adjust the conveyor width exceeding the maximum or minimum
width.
[Solution]
Perform setup of the width adjustment according to the specification of the current
machine..
$3060 Attempt was made to adjust the conveyor width while the conveyor width was already
being adjusted.. [EMER LEVEL]
$3061 The conveyor needs to be homed. [EMER LEVEL]
[Problem]
When operating the conveyor that was not homed.
[Solution]
Turn off the Buzzer by pressing the “STOP” button.
Switch the machine to “IDLE” mode by pressing the “RESET” button.
Supply power to the motor of the machine by pressing the “READY” button.
Home all axes related to conveyor and perform operation related to conveyor.
$3067 Cannot begin production since the conveyor rail width does not match with the PCB
width. [EMER LEVEL]
[Problem]
There is difference between conveyor stations.
[Solution]
Turn off the Buzzer by pressing the “STOP” button.
Switch the machine to “IDLE” mode by pressing the “RESET” button.
Supply power to the motor of the machine by pressing the “READY” button.