88192278-01-19 Installation Master.pdf - 第126页

PRINTER PREPARATION PRINTER HEIGHT AND LEVELLING 4.24 Installation Manual Chapter Issue 15, May 20 direction. 12. M ove the engineering level along the cent re row of screws running from front to back. 13. C hange the or…

100%1 / 226
PRINTER PREPARATION
PRINTER HEIGHT AND LEVELLING
Chapter Issue 15, May 20 Installation Manual 4.23
conveyor.
3. Lower the printer and check that mounting foot (1) and (2) are sitting on the
floor and foot (3) and foot (4) are sitting on the floor plate.
4. Raise printer A and move it out of position to gain access to the rear of printer
B.
5. Place foot (6) under the front of printer B in the centre.
6. Check the orientation of foot (6) as shown above.
NOTE
Avoid the seam weld to ensure the printer is properly supported.
7. Raise the front centre levelling foot (6) to make contact with the printer.
8. Raise the front left foot (1) and front right foot (2) so they are not in contact
with the floor and the printer is supported on the centre mounting foot (6).
9. Apply pneumatic power to the printer to set the rails to the correct height for
printer levelling.
10. Place an engineering level on top of the manual tooling plate along the front
row of screws running from left to right.
11. Adjust the rear left mounting foot (3) and foot (4) to level the printer in the X
Seam WeldLevelling Foot (6)
Front below FrameView Machine
Engineering LevelManual Tooling Plate
Isometric View on Manual Tooling Plate
Front
Centre Line
(Y direction)
Centre Line
(X direction)
PRINTER PREPARATION
PRINTER HEIGHT AND LEVELLING
4.24 Installation Manual Chapter Issue 15, May 20
direction.
12. Move the engineering level along the centre row of screws running from front
to back.
13. Change the orientation of the Level and adjust the front centre mounting foot
(6) to level the printer in the Y direction.
14. Adjust the front centre mounting foot (6) to level the printer in the Y direction.
15. Repeat Steps 11 to 14 until the printer is level in both directions.
16. Carefully lower the front left mounting foot (1) so that it is in contact with the
floor.
17. Recheck the printer level has not been disturbed.
18. Carefully lower the front right mounting foot (2) so that it is in contact with
the floor.
19. Recheck the printer level has not been disturbed.
20. Lower the front centre mounting foot (6) so it is not in contact with the printer.
21. Remove the front centre mounting foot (6) and store in a safe place.
22. Tighten mounting feet locknuts.
23. Recheck the printer is level.
24. Recheck the printer height has not been disturbed.
25. Remove the engineering level from the printer.
26. Position the V-block so contact is made with the locating collar on foot (4).
PRINTER PREPARATION
PRINTER HEIGHT AND LEVELLING
Chapter Issue 15, May 20 Installation Manual 4.25
27. Position the location block so contact is made with the locating collar on foot
(3).
28. Fully tighten the fixing screws securing both location blocks.
29. Position the locator blocks for printer B to achieve maximum adjustment,
and ensure parallel to the locator blocks for printer A.
30. Rotate the stopper bolts by hand until they make contact with the opposing
block, and then secure them using the locknuts.
31. Move printer A back into position locating foot (3) into V-Block.
32. Position locating foot (4) against Locating Block.
33. Recheck the printer is level.
34. Recheck the printer height has not been disturbed.
V-Block
Fixing Screws
Location-Block
Fixing Screws
Stopper Bolts