88192278-01-19 Installation Master.pdf - 第47页
COVERS PRINTER COVERS Chapter Issue 12, Feb 18 Installation Manual 2.13 4mm Hexagonal Head Quarter-T urn Fasteners T o prevent personnel from having direct acce ss to areas of the printer where safety hazards exist, the …
COVERS
PRINTER COVERS
2.12 Installation Manual Chapter Issue 12, Feb 18
Cover Removal Before removing covers ensure that the supplies (air and electrical) have been
isolated from the printer.
Quarter-Turn Ring
Fasteners
To remove a panel secured with quarter-turn ring fasteners, turn the fastener
ring anti clockwise (-) by a quarter-turn and pull out. To refit a panel, locate the
fastener shaft into the fastener, push against the spring whilst turning the ring
clockwise a quarter turn to secure (+).
Figure 2-3 Quarter-Turn Ring Fastener
Figure 2-4 Ring Fastener Locations
+
-
Locations (behind panels) of the Quarter Turn Ring Fasteners
Front Left Quarter
Rear Left Quarter
COVERS
PRINTER COVERS
Chapter Issue 12, Feb 18 Installation Manual 2.13
4mm Hexagonal
Head Quarter-Turn
Fasteners
To prevent personnel from having direct access to areas of the printer where
safety hazards exist, the front and rear panels each have two hexagonal head
fasteners. These fasteners are covered by the sliding cover, in the front of the
printer, and the rear printhead cover, at the back. Once access is gained, a 4mm
Allen Key is used to release the fasteners on the top of the panel.
Figure 2-5 Front Safety Fasteners
Figure 2-6 Rear Safety Fasteners
Locating Pins Side, corner, front and rear panels are secured on location pins at the base of
the printer. Plates mounted on each corner of the printer (see vignette below)
house the four pins; the two centre pins are for the corner panels and two outer
pins are for the side, front and rear panels.
4mm Hexagonal Head
Quarter-Turn Fastener
View on Printer Rear Right Corner
4mm Hexagonal Head
Quarter-Turn Fastener
View on Printer Front Right Corner
COVERS
PRINTER COVERS
2.14 Installation Manual Chapter Issue 12, Feb 18
Figure 2-7 Mounting Plates
Front Panel To remove the front panel, carry out the following:
1. Open the sliding cover.
2. Release the two quarter-turn safety fasteners located externally at the top
corners of the panel.
3. Tilt the top of the panel away from the printer and lift the panel clear of the
location pins at the bottom.
Rear Panel To remove the rear panel, carry out the following:
1. Lift the rear printhead cover.
2. Release the two quarter-turn safety fasteners located externally at the top
corners of the panel.
3. Tilt the top of the panel away from the printer and lift the panel clear of the
location pins at the bottom.
Corner Panel
Location Pins
View on Base of Printer
Location Pins
Side, Front &
Rear Panels
Quarter-turn fasteners