88192278-01-19 Installation Master.pdf - 第149页
PRINTER PREPARATION PRINTER ASSEMBLY Chapter Issue 15, May 20 Installation Manual 4.47 conveyor height adjustment bolts. 3. Adjust the position of the conveyor to obtain the 3.5mm ±0.5 mm gap between the front and rear r…
PRINTER PREPARATION
PRINTER ASSEMBLY
4.46 Installation Manual Chapter Issue 15, May 20
Auxiliary Conveyor
to Print Station
Gap
To check and if required adjust the gaps between the print station rail and the
auxiliary conveyors carry out the following procedure:
NOTE
To carry out this procedure on the front rail, the board stops between the print
station and the auxiliary conveyors must be removed.
1. Using feeler gauges, ensure that the gap between the print station and the
auxiliary conveyors (in four positions) is 3.5mm ±0.5mm.
2. If adjustment is required, loosen the locking nuts on the two auxiliary
Front View of HTC Rails
3.5 ±0.5mm
PRINTER PREPARATION
PRINTER ASSEMBLY
Chapter Issue 15, May 20 Installation Manual 4.47
conveyor height adjustment bolts.
3. Adjust the position of the conveyor to obtain the 3.5mm ±0.5mm gap
between the front and rear rails of the auxiliary conveyor and the front and
rear rails of the print station.
4. Re-tighten the locking nuts disturbed in Step 2 and re-check the gap
measurement.
5. On completion, carry out Auxiliary Conveyor Front Rail Parallelism check.
Auxiliary Conveyor
Levelling
To check and if required adjust the levelling of the auxiliary conveyors, carry out
the following procedure:
1. Manually adjust the auxiliary conveyor rail width to 250mm.
2. Place a Board Clamp Setting Plate Part No. 140403 onto the auxiliary
conveyor transport belts.
3. Place a spirit level on top of the setting plate and check the levelness of the
Auxiliary Conveyor
Height Adjustment
Bolt
Locking Nut
PRINTER PREPARATION
PRINTER ASSEMBLY
4.48 Installation Manual Chapter Issue 15, May 20
conveyor in the X and Y planes.
4. If adjustment is required, carry out the following:
a. By careful adjustment of the grub screws on the top face of the auxiliary
conveyor front and rear linear bearing holders, raise or lower the height
of the conveyor about the auxiliary conveyor height adjustment bolt, to
achieve conveyor levelness.
b. Carry out Steps 2 and 3 to re-check for conveyor levelness.
View on Auxiliary Conveyor
Y
Board Clamp
Setting Plate
Spirit Level
X
Front View of HTC Rails
Grub Screw
Linear Bearing
Linear Bearing Holder