88192278-01-19 Installation Master.pdf - 第46页
COVERS PRINTER COVERS 2.12 Installation Manual Chapter Issue 12, Feb 18 Cover Removal Before removing covers ensure that the supplies (air and electrical) have been isolated from the printer . Quarter-T urn Ring Fastener…
COVERS
PRINTER COVERS
Chapter Issue 12, Feb 18 Installation Manual 2.11
Type 2 Covers In order to protect personnel and prevent damage to the printer, 10 covers are
fitted to the printer.
The sliding cover, the rear printhead cover and two upper side panels which
house the control switches protect the upper part of the printer. The four corner
panels, front and rear panels, safety covers and the front and rear side panels
protect the lower part of the printer.
NOTE
Some of the covers can only be removed in a specific order due to the covers
interlocking with each other.
Item Description Item Description
1 Rear Printhead Cover 7 Front Side Panel (2 positions)
2 Sliding Cover 8 Front Panel
3 Right Hand Upper Side Panel 9 Front Corner Panel (2 positions)
4 Rear Corner Panel (2 positions) 10 Left Hand Upper Side Panel
5 Safety Cover (2 positions) 11 Rear Panel
6 Rear Side Panel (2 positions)
Front Left Quarter View
10
9
8
7
6
4
5
1
3
2
11
COVERS
PRINTER COVERS
2.12 Installation Manual Chapter Issue 12, Feb 18
Cover Removal Before removing covers ensure that the supplies (air and electrical) have been
isolated from the printer.
Quarter-Turn Ring
Fasteners
To remove a panel secured with quarter-turn ring fasteners, turn the fastener
ring anti clockwise (-) by a quarter-turn and pull out. To refit a panel, locate the
fastener shaft into the fastener, push against the spring whilst turning the ring
clockwise a quarter turn to secure (+).
Figure 2-3 Quarter-Turn Ring Fastener
Figure 2-4 Ring Fastener Locations
+
-
Locations (behind panels) of the Quarter Turn Ring Fasteners
Front Left Quarter
Rear Left Quarter
COVERS
PRINTER COVERS
Chapter Issue 12, Feb 18 Installation Manual 2.13
4mm Hexagonal
Head Quarter-Turn
Fasteners
To prevent personnel from having direct access to areas of the printer where
safety hazards exist, the front and rear panels each have two hexagonal head
fasteners. These fasteners are covered by the sliding cover, in the front of the
printer, and the rear printhead cover, at the back. Once access is gained, a 4mm
Allen Key is used to release the fasteners on the top of the panel.
Figure 2-5 Front Safety Fasteners
Figure 2-6 Rear Safety Fasteners
Locating Pins Side, corner, front and rear panels are secured on location pins at the base of
the printer. Plates mounted on each corner of the printer (see vignette below)
house the four pins; the two centre pins are for the corner panels and two outer
pins are for the side, front and rear panels.
4mm Hexagonal Head
Quarter-Turn Fastener
View on Printer Rear Right Corner
4mm Hexagonal Head
Quarter-Turn Fastener
View on Printer Front Right Corner