88192278-01-19 Installation Master.pdf - 第61页
COVERS PRINTER COVERS Chapter Issue 12, Feb 18 Installation Manual 2.27 4. T o disconnect the system switch and jog buttons carry out the following: a. Locate the two release slot s in the contact assembly part of the sw…
COVERS
PRINTER COVERS
2.26 Installation Manual Chapter Issue 12, Feb 18
5. Repeat Steps 3 and 4 for the other rear corner panel, if required.
Front Corner Panels To remove the front corner panels, carry out the following:
1. Open the front printhead cover.
2. Remove the front panel (as detailed previously).
NOTE
1. Before a front corner panel can be removed, the control switches (jog
switch and system switch or jog switch and E Stop) must be disconnected.
2. Before removing the right hand front corner panel, disconnect the connec-
tor for the printhead safety switch.
3. Locate the two release slots in the contact assembly part of the
switch.
View on Rear of Switch
1 Release Slot 3 Switch Body
2 Contact Assembly
COVERS
PRINTER COVERS
Chapter Issue 12, Feb 18 Installation Manual 2.27
4. To disconnect the system switch and jog buttons carry out the following:
a. Locate the two release slots in the contact assembly part of the switch.
b. Insert the switch release tool (Part No 188647) into the slots and push
until the release tool clicks into place.
c. Leaving the switch release tool in position, pull the contact assembly from
the switch body.
d. Remove the switch release tool from the contact assembly.
NOTE
To refit the contact assembly to the switch body, using the locating
keyway, push the two units together until they click into place.
View on Rear of Switch
1 Switch Body
2 Contact Assembly
3 Switch Release Tool
COVERS
PRINTER COVERS
2.28 Installation Manual Chapter Issue 12, Feb 18
5. To disconnect the E Stop, turn the latch anti-clockwise and pull the contact
assembly away from the cover.
6. Undo the appropriate M5 captive screws (refer to rear corner panels figure
for screw position).
7. Lift the panel clear of the printer, taking care not to damage the earth cable.
8. Repeat Steps 3 to 6 for the other front corner panel, if required.
Lower Side Panels To remove the lower side panels, carry out the following:
1. Remove the corresponding safety cover (as detailed previously).
2. Open the front printhead cover.
3. Remove the front panel (as detailed previously).
4. Remove the rear panel (as detailed previously).
5. Remove the rear fixed printhead cover (as detailed previously).
6. Remove the corresponding rear corner panel (as detailed previously).
7. Remove the corresponding front corner panel (as detailed previously).
8. Using an 4mm Allen key, undo the two captive screws.
Contact Assembly Latch
View on Rear of E Stop
View on Left Hand Side of Machine
M5 Captive
Screws