88192278-01-19 Installation Master.pdf - 第215页
INSTALLATION DOCUMENTATION INSTALLATION CHECKLIST Chapter Issue 6, Nov 19 Installation Manual 9.3 No. Machine Performance Reference Completed 19 Machine Alignment Capability: Chapter 8 Cp Cpk No Change X Alignment Y Alig…
INSTALLATION DOCUMENTATION
INSTALLATION CHECKLIST
9.2 Installation Manual Chapter Issue 6, Nov 19
INSTALLATION CHECKLIST
No. Machine Preparation Reference Completed
1 Check Machine for Transit Damage Chapter 4
2 Check Accessories are Correct to the Packing list
3 Transport to Final Destination
4 Remove Transit Brackets
5 Set Machine Height and Level
6 Fit Machine Components
7 Carry out Pre Power Up Checks
No. Power Up Sequence Reference Completed
8 Measure Customer Factory Electrical Supply Chapter 5
9 Set Time and Date
10 Check Correct Operation of E Stop Loop compo-
nents
11 Carry out Paste Dispenser Function Check
12 Carry out Stencil Clean Function Check
No. High Throughput Conveyor (HTC) Reference Completed
13 HTC Setup Chapter 6
14 Check the HTC is Correctly Configured
15 Check Operation of the Conveyors
No. FMI Reference Completed
16 Check the MIU is Correctly Configured Chapter 7
17 Check that MIU is Selected
18 Check Operation of Interface
INSTALLATION DOCUMENTATION
INSTALLATION CHECKLIST
Chapter Issue 6, Nov 19 Installation Manual 9.3
No. Machine Performance Reference Completed
19 Machine Alignment Capability: Chapter 8
Cp Cpk No
Change
X Alignment
Y Alignment
θ Alignment
Process Alignment Capability
Cp Cpk No
Change
X Alignment
Y Alignment
θ Alignment
No. Machine Performance Upgrades (MPU’s) Reference Completed
20 Fit all MPU’s and Record in the Table Below
(Record N/A for MPU’s not supplied)
N/A
MPU Number Description Fitted
602315*1 250mm Board Clamps
602316*1 Foil-less Board Clamps
602317*1 Vacuum Cup Tooling
602323*1 300mm Under Stencil Cleaner
602324*1 520mm Under Stencil Cleaner
602325*1 10sec Cycle Time
602327*1 Advanced SPC
No. Documentation Reference Completed
21 Service Report
22 Acceptance Document Chapter 9
23 Merlin Installation Report
No. Service Due Reference Completed
24 Check the Next Service Due label has been filled in
(located on the rear panel)
N/A
No. 5th Leg Reference Completed
25 Check the fifth leg has been wound up (see warning
label located on the rear panel)
N/A
INSTALLATION DOCUMENTATION
INSTALLATION CHECKLIST
9.4 Installation Manual Chapter Issue 6, Nov 19
NOTE
On style 1, 2, 3 and 5 printers, the model number and serial number can be
found on the label at the rear of the machine. On style 4 machines, the model
number and serial number can be found on the label positioned left or right hand
side of the printer.
No. On Site Training Reference Completed
26 Training at Installation Chapter 6
MACHINE MODEL
MACHINE SERIAL NUMBER