1OM-1003-007.pdf - 第139页

2.4 End of Pass Operation 2.4.1 Stop of Pass Operation (1) Press the [STOP] button on the front operation panel. The LED of the [ST ART] button and the green lamp of the light tower extinguish and the automatic operation…

2.2 Temporary Stop of Pass Operation

2.2.1 Temporary Stop (Pause) with [STOP] Button

When the [STOP] button on the front operation panel is pressed, each

device returns to its stationary position and the "PASS" operation stops

temporarily.

2.3 Interruption of Pass Operation

2.3.1 Interruption with [CANCEL] Button

When the machine is set in the "PAUSE" mode, an [INTERRUPT] but-

ton appears in the "Run Mode" tab sheet. (Operation Sequence: "[OPN.

MODE] Button on Submenu Bar" à "Run Mode" Tab Sheet)

When the [INTERRUPT] button is pressed, the machine is set in the

"STOP" mode.

2.3.2 Interruption with [EMERGENCY STOP] Switch

Use the [EMERGENCY STOP] switch to immediately stop the machine

in an emergency.

Fig. 1C38

••

• Stop Operation

(1) Press the [EMERGENCY STOP] switch.

The machine stops running, an error alarm is issued, and the LED

of the [POWER ON] button illuminates in red.

Refer to "Section 4 Remedy of Simple Trouble" in "Volume 1"

for the procedures to reset the machine to the normal condition

from an emergency stop.

2.2 Temporary Stop of Pass Operation

0305-001 3-27 AIL01EOPP

Note

2.4 End of Pass Operation

2.4.1 Stop of Pass Operation

(1) Press the [STOP] button on the front operation panel.

The LED of the [START] button and the green lamp of the light

tower extinguish and the automatic operation stops.

Remove the P.C.B. in the middle of passing inside the machine

if any.

(2) Press the [ALL] button (entitled "ZERO") in the "AUTO OPN." win-

dow. In 2 seconds, press the [ENABLE] button on the operation

panel.

2.4.2 Shut-Down Operation

Follow the procedure in "1.7 Shut-Down Operation" and shut down the

power supply.

2.4 End of Pass Operation

0305-001 3-28 AIL01EOPP

Note

Section 4

Remedy of Simple Trouble

0305-001 4-A AIL01EOPP

This section describes how to troubleshoot simple problems

that can be solved by the machine operator.

When the operator cannot solve a problem, he/she should

get in contact with the supervisor (a person in charge of

machine management).