DECAN_S1_Troubleshooting_Guide(Eng_Ver1.3)_Print_Web.pdf - 第129页
1-105 System Messages of the MMI and Solutions Check if the shutter operates correctly by clicking ‘Shutter On/Off’ on the ANC dialog box.
1-104
Next Generation, Multi-Functional Placer DECAN S1 Troubleshooting Guide
Check if the supplied pneumatic pressure is as high as the set pressure (0.45 ~ 0.55
MPa) by the air pressure gauge through air panel on the front side of the machine.
1: Pressure Decrease (Counterclockwise)
2: Pressure increase (Clockwise)
$6030 Nozzle in the head. Can't put. [FREEZE LEVEL]
[Problem]
Following the nozzle ‘PUT’ operation, if the ANC hole center is not aligned, the
nozzle put operation is performed due to inadequate height setup, or the nozzle
actually mounted on the head, etc.
[Solution]
Turn off the Buzzer by pressing the “STOP” button.
Switch the machine to “IDLE” mode by pressing the “RESET” button.
Press the “READY” button to supply power to the machine.
After clicking the ‘Fiducial Mark Detail…’ on the ANC dialog box, move to the
fiducial mark to check if the fiducial mark position is properly setup. If not, perform
teaching again. For details on teaching, please refer to “6.3 Fiducial Mark Setup” in
the “Administrator’s Guide”.
1-105
System Messages of the MMI and Solutions
Check if the shutter operates correctly by clicking ‘Shutter On/Off’ on the ANC dialog
box.
1-106
Next Generation, Multi-Functional Placer DECAN S1 Troubleshooting Guide
$6040 Z axis couldn't move to the put position. [FREEZE LEVEL]
[Problem]
Errors occurred while moving down the Z-axis for the nozzle ‘Put’ operation.
[Solution]
Check the position of the corresponding ANC hole and Z-axis offset.
For the ANC position check, refer to the ‘ANC hole position check’ in the
[Countermeasure] in $6030. Ensure if the Z-axis offset value of the corresponding
head is correctly set up.
For calibration of the Z-axis offset, refer to the “12.3.10.2 Head Z / R Offset
Calibration” in the “Administrator’s Guide”.
$6050 Z axis couldn't move to a safe height after putting. [FREEZE LEVEL]
[Problem]
Errors occurred while moving up the Z-axis for the nozzle ‘Put’ operation.
[Solution]
Perform [Solution] in $6040.
$6060 Can't get, nozzle in the head. [FREEZE LEVEL]
[Problem]
Nozzle actually exists when trying to get nozzle.
[Solution]
Turn off the Buzzer by pressing the “STOP” button.
Switch the machine to “IDLE” mode by pressing the “RESET” button.