DECAN_S1_Troubleshooting_Guide(Eng_Ver1.3)_Print_Web.pdf - 第64页
1-40 Next Generation, Multi-Functional Plac er DECAN S1 Troubleshooting Guide 2) Setup for part re cognition w as performed so that the fiducial ma rk shall be recognized after recognizing a bad mark [Measures] 1) Set th…
1-39
System Messages of the MMI and Solutions
2) Emboss tape reel is used for an 8mm 4 pitch feeder that uses a paper tape reel.
[Measures]
1) Check whether parts are lifted off when peeling vinyl from the tape manually. Replace
the tape when there is a problem.
2) Check whether the reel installed in the feeder is the correct one. Use an emboss tape
feeder for an emboss tape reel.
E0462 A part stands on an edge or is flipped over due to a deformation of the tape guide and
tape shutter
[Cause]
1) Deformation of tape guide due to external impact
2) Deformed shutter interferes with a part.
[Measures]
1) Contact our designated C/S company or local agent. (Replace the tape guide)
2) Contact our designated C/S company or local agent. (Replace the shutter)
E0463 A part stands on an edge or is flipped over due to abnormal shutter operation
[Cause]
Defective operation of shutter
[Measures]
Check whether the shutter operates smoothly. If it has a problem, apply grease to it
referring to the tape feeder manual.
E0470 Temporary vision recognition error occurred
[Cause]
Defective or incorrect parts were recognized as normal due to a temporary vision
recognition problem
[Measures]
Check whether there is a vision recognition problem by performing a part recognition
test several times with various parts. If the problem occurs continuously, contact our
designated C/S company or local agent.
E0480 Setup for part recognition was performed so that the fiducial mark shall be recognized
after
recognizing a bad mark
[Cause]
1) Different bad mark size
1-40
Next Generation, Multi-Functional Placer DECAN S1 Troubleshooting Guide
2) Setup for part recognition was performed so that the fiducial mark shall be recognized
after recognizing a bad mark
[Measures]
1) Set the bad mark parameter again.
2) Perform setup so that the bad mark shall be recognized after recognizing the fiducial
mark.
1-41
System Messages of the MMI and Solutions
1.3. Measures against a vision recognition related error
1.3.1. Classification of Error Codes
Error code Details Note
a401 ~ a423 General errors (timeout, out of margin, unregistered part,
etc.)
a500 ~ a504 HEMT related error
a5a0 ~ a5d4 Split recognition related error
a610 ~ a682 LLSL related error
a715~ a765 CONN related error
a805 ~ a869 ODD related error
a910 ~ a931 BGA related error
aa00 ~ aa2b MELF related error
ab00 ~ ab2b TR related error
ac00 ~ ac14 VC related error
ad01 ~ ad30 Auto teaching related error
ae03 ~ ae16 Fiducial related error
af02 ~ af07 Pocket teaching related error
af51 ~ af56 Flip chip related error
af81 ~ af85 Lens distortion calibration related error
af90 ~ af95 Board recognition mark error