DECAN_S1_Troubleshooting_Guide(Eng_Ver1.3)_Print_Web.pdf - 第63页
1-39 System Messages of the MMI and Solutions 2) Emboss tape reel is used for an 8mm 4 pitch feeder that uses a paper tape reel. [Measures] 1) Check whether parts are lifted off when peelin g vinyl from the tape manually…
1-38
Next Generation, Multi-Functional Placer DECAN S1 Troubleshooting Guide
Turn off the coaxial and inner illumination and adjust the brightness with only the
outer illumination.
E0445 Parts are placed incorrectly in the uniform state only for specific PCB
[Cause]
Damaged fiducial mark
[Measures]
Clean the contaminated fiducial mark.
E0446 The fiducial mark has not been set
[Cause]
The fiducial mark has not been set
[Measures]
If the fiducial mark is not set up, parts will not be placed properly in various forms for
most PCBs. Check the fiducial mark setup again.
E0450 Incorrect setup of the coordinate for part placement
[Cause]
For all PCBs, all parts were placed incorrectly in the uniform state.
[Measures]
Set the placement origin of the corresponding PCB again.
E0451 For Array PCB, all parts were placed incorrectly only on the specific PCB in the
uniform state.
[Cause]
Incorrect Array setup
[Measures]
Set the Array Offset of the corresponding PCB again.
E0460 An LED part was placed being flipped over or with its polarity being changed
[Cause]
The algorithm for reverse insertion and flip-over of the LED is not applied.
[Measures]
Use the 'LED Flip Check' function referring to the Administrator's Guide.
E0461 A part stands on an edge or is flipped over due to a defective tape reel
[Cause]
1) Part is lifted by static electricity generated due to defective tape reel.
1-39
System Messages of the MMI and Solutions
2) Emboss tape reel is used for an 8mm 4 pitch feeder that uses a paper tape reel.
[Measures]
1) Check whether parts are lifted off when peeling vinyl from the tape manually. Replace
the tape when there is a problem.
2) Check whether the reel installed in the feeder is the correct one. Use an emboss tape
feeder for an emboss tape reel.
E0462 A part stands on an edge or is flipped over due to a deformation of the tape guide and
tape shutter
[Cause]
1) Deformation of tape guide due to external impact
2) Deformed shutter interferes with a part.
[Measures]
1) Contact our designated C/S company or local agent. (Replace the tape guide)
2) Contact our designated C/S company or local agent. (Replace the shutter)
E0463 A part stands on an edge or is flipped over due to abnormal shutter operation
[Cause]
Defective operation of shutter
[Measures]
Check whether the shutter operates smoothly. If it has a problem, apply grease to it
referring to the tape feeder manual.
E0470 Temporary vision recognition error occurred
[Cause]
Defective or incorrect parts were recognized as normal due to a temporary vision
recognition problem
[Measures]
Check whether there is a vision recognition problem by performing a part recognition
test several times with various parts. If the problem occurs continuously, contact our
designated C/S company or local agent.
E0480 Setup for part recognition was performed so that the fiducial mark shall be recognized
after
recognizing a bad mark
[Cause]
1) Different bad mark size
1-40
Next Generation, Multi-Functional Placer DECAN S1 Troubleshooting Guide
2) Setup for part recognition was performed so that the fiducial mark shall be recognized
after recognizing a bad mark
[Measures]
1) Set the bad mark parameter again.
2) Perform setup so that the bad mark shall be recognized after recognizing the fiducial
mark.