TUT-CP842-Oper guide-preliminary.pdf.pdf - 第36页
Setting the Recovery Limit When [Machine] is selected as the [Recovery Reference] setting, the number of recoveries (recovery limit) which are to occur must be specified as described below . Procedure 1. Select [Recovery…
Setting the “Recovery Reference” Data
A “Recovery Limit” setting must be specified when the “Auto Recovery”
mode is selected. The “Recovery Reference” setting permits the selection of
either the machine’s “Recovery Limit” setting or the Part data “Recovery
Limit” setting.
<Explanation of recovery reference data>
Machine: The recovery limit setting at the machine applies to all parts.
Part data: The recovery limit for each part is determined by the recovery
limit setting in the Part data for that part.
Note: When the [Machine] setting is selected, the recovery limit setting
described in the following section is also required.
Procedure
1. Select [Recovery] at the [Main] screen.
2. Select [Auto Recovery].
3. Select [Machine] or [Part Data] from the [Recovery Reference]
section.
4. Press [Close] to return to the [Main] screen.
Chapter 3: Preparing for Production
Preliminary
3-5CP-842E/842ME Operator’s Guide
Setting the Recovery Limit
When [Machine] is selected as the [Recovery Reference] setting, the number
of recoveries (recovery limit) which are to occur must be specified as
described below.
Procedure
1. Select [Recovery] from the [Main] screen.
2. Select [Auto Recovery].
3. Select [Machine] from the [Recovery Reference] section.
4. Press [Change] in [Recovery Limit].
5. Input the number of times recovery is to be attempted using the
numeric keypad that displays and then press [OK].
6. The numeric keypad will then disappear and the recovery limit
setting will be enabled.
7. Press [Close] to return to the [Main] screen.
Chapter 3: Preparing for Production
Preliminary
3-6 CP-842E/842ME Operator’s Guide
Setting the Recovery Timing/Stop Mode at
Recovery Up
When Auto Recovery has been selected, recovery timing and stop mode at
recovery up must be specified.
Procedure
1. Select [Recovery] from the [Main] screen.
2. Select [Immediate] or [Delayed] from the [Recovery Timing]
section.
3. Select [Stop] or [Continuous] from the [Stop Mode at Recovery
Up] section.
Notes: 1. These settings are available when the recovery mode is set to
[Auto Recovery].
2. Refer to the CP-842E/842ME System Reference manual for
an explanation of recovery modes.
4. Press [Close] to return to the [Main] screen.
Chapter 3: Preparing for Production
Preliminary
3-7CP-842E/842ME Operator’s Guide