TUT-CP842-Oper guide-preliminary.pdf.pdf - 第66页
Notes Chapter 6: Finishing Production Preliminary 6-4 CP-842E/842ME Operator ’s Guide
It is possible to automatically stop the machine when all panels in the machine
(in-conveyor, in-carrier, and XY-table) are produced and the last one is
unloaded to the out-conveyor.
Procedure
1. Press [Finish All Panels] while production is in progress on the
machine.
2. The machine will automatically stop after all panels on the in-
conveyor, in-carrier, and XY-table have been produced and
unlaoded.
Note: If a panel is not unloaded to the next machine and the panel is left on the
out-conveyor, panels on the out-carrier and XY-table cannot be unloaded.
Remove the panels on the out-conveyor in order.
6.3 Stopping Production Automatically After
All Panels Remaining in the Machine are
Completed
Chapter 6: Finishing Production
Preliminary
6-3CP-842E/842ME Operator’s Guide
Notes
Chapter 6: Finishing Production
Preliminary
6-4 CP-842E/842ME Operator’s Guide
Chapter 7
Maintenance
7.1 Cleaning the Waste Tape Box and Filter
7.2 Cleaning the Waste Tape Suction Path
7.3 Emptying the Reject Parts Box
7.4 Cleaning Nozzles
7.5 Cleaning the Camera Glass
7.6 Cleaning the Part Height Check Sensor Lens
7.7 Cleaning the Surface of the Fluorescent Disk Seals
7.8 Cleaning the Tapered Cluches on the Nozzle Indexing Shaft
7.9 Cleaning the Inside of the Machine
Preliminary
7-1CP-842E/842ME Operator’s Guide