TUT-CP842-Oper guide-preliminary.pdf.pdf - 第75页
Frequency Once a month Procedure W ARNING • Turn the 200V power of f before performing this proce- dure. • Rotation may occur (caused by spring action) if the cam axis is not at its origin position (0-degrees). Use speci…
Frequency
Once a month
Procedure
Use a soft brush (such as those used to clean camera lenses) to wipe the dust
from the sticker. Do not rub the fluorescent seal with a cloth, as this will cause
dust to adhere to it. If the dust cannot be removed, replace the fluorescent
seal.
.
7.7 Cleaning the Surface of the
Fluorescent Disk Seals
Chapter 7: Maintenance
Preliminary
7-8 CP-842E/842ME Operator’s Guide
Frequency
Once a month
Procedure
WARNING
• Turn the 200V power off before performing this proce-
dure.
• Rotation may occur (caused by spring action) if the cam
axis is not at its origin position (0-degrees).
Use special care when working inside the machine as
this is a dangerous area.
While pulling down the outer shaft which covers the nozzle indexing shaft,
wipe the tapered clutch (all the way around) with a cloth on which the degreas-
ing agent (Threebond2706) has been applied.
Note: Do not spray the degreasing agent directly onto the tapered clutch,
because spraying is inaccurate. (The agent could land on other compo-
nents, removing the lubricant which they require.)
7.8 Cleaning the Tapered Clutch on the
Nozzle Indexing Shaft
Chapter 7: Maintenance
Preliminary
7-9CP-842E/842ME Operator’s Guide
Frequency
Once a month
Procedure
WARNING
Be sure to turn the 200V power off before performing this
procedure.
• Use a vacuum cleaner to remove the foreign objects from the machine inte-
rior.
• Use a dry cloth to wipe grease off of all areas not specified as lubrication
points.
Note: Do not use an air gun within the machine as dust or other small fragments
may be blown into other areas of the machine.
7.9 Cleaning the Inside of the Machine
Chapter 7: Maintenance
Preliminary
7-10 CP-842E/842ME Operator’s Guide