TUT-CP842-Oper guide-preliminary.pdf.pdf - 第57页
W ith the necessary checks complete, production can now commence. Either the auto operation or step operation mode must be used to operate the machine and place parts on a panel. Rather than directly entering auto operat…
4. Repeat steps 2 and 3 above until a “Parts Available” status
exists for all devices which are to be used in production.
Notes: 1. As an alternative to the above procedure, all parts devices can be
checked in a single operation by using the following commands:
[Select All] - [Set Devices]
2. Refer to the CP-842E/842ME System Reference manual for details on
device check measurement.
3. Even when the above operation is not carried out, if the parts settings
for the current program differ from the parts settings of the program
used in production to that point, the differences in the parts settings
will be displayed and the device check command will be entered auto-
matically at the time automatic or step operation is entered. Note how-
ever that this check may not function depending on the Proper data set-
ting.
Chapter 4: Starting Production
Preliminary
4-4 CP-842E/842ME Operator’s Guide
With the necessary checks complete, production can now commence. Either
the auto operation or step operation mode must be used to operate the machine
and place parts on a panel. Rather than directly entering auto operation, it is
best to use the step operation mode to operate the machine one cycle at a time
for several cycles to check that parts are being placed correctly on the panel.
If there are no problems then enter auto operation at that time.
Step Operation
Procedure
1. Select [Production] at the [Main] screen.
2. Select [Step] from the [Production Mode] section.
3.
Press the START button.
Notes: 1. If the nozzle check display appears on the operation panel, replace the
nozzle following the procedure given in section 3-5 Nozzle
Replacement. Once this is done make the necessary preparations in
accordance with the procedure outlined in Nozzle set check given in
this section and then enter Step operation.
2. If the device check display appears on the operation panel, follow the
procedure in Parts Set Check in section 4-1 to make the necessary
preparations and then enter Step operation.
4.2 Starting Production
Chapter 4: Starting Production
Preliminary
4-5CP-842E/842ME Operator’s Guide
Automatic Operation
Procedure
1. Select [Production] at the [Main] screen.
2. Select [Automatic] from the [Production Mode] section.
3. Press the START button.
Notes: 1. If the nozzle check display appears on the operation panel, replace the
nozzle following the procedure given in section 3-5 Nozzle
Replacement. Once this is done make the necessary preparations in
accordance with the procedure outlined in Nozzle set check given in
this section and then enter Step operation.
2. If the device check display appears on the operation panel, follow the
procedure in Parts Set Check in section 4-1 to make the necessary
preparations and then enter Step operation.
Chapter 4: Starting Production
Preliminary
4-6 CP-842E/842ME Operator’s Guide