TUT-CP842-Oper guide-preliminary.pdf.pdf - 第80页
A new panel can be loaded onto the XY -table by means of a command opera- tion. This can also be used when a panel is already on the XY -table and the new panel is to be loaded after the existing panel is unloaded. The p…
It is possible to set the sequence from which production is to start. This oper-
ation must be carried out with the panel on the XY-table.
Procedure
1. Select [Production] from the [Main] screen.
2. Then select [Start Sequence].
3. Select [Production Start Number].
4. Use the numeric keypad to input the number of the sequence
from which production is to start.
5. Press the START button.
Note: If fiducial mark acquisition has not been completed for the panel on the
XY-table, production will start from the specified sequence but after the
fiducial marks are read.
8.2 Setting the Production Start Sequence
Chapter 8: Production Support Functions
Preliminary
8-3CP-842E/842ME Operator’s Guide
A new panel can be loaded onto the XY-table by means of a command opera-
tion. This can also be used when a panel is already on the XY-table and the
new panel is to be loaded after the existing panel is unloaded. The panels can
be changed using the following operation.
Procedure
1. Select [Panel Loader] from the [Setup] section at the [Main]
screen.
2. Select [Load Panel].
3.
Press the START button.
All panels from the XY-table to the out-conveyor can be unloaded. Remove
the panels in order as they are unloaded to the out-conveyor.
Procedure
1. Select [Panel Loader] from the [Setup] section at the [Main]
screen.
2. Select [Unload] from the [Load/Unload] section.
3. Press the START button.
8.4 Unloading Panels From the XY-table
8.3 Loading a New Panel
Chapter 8: Production Support Functions
Preliminary
8-4 CP-842E/842ME Operator’s Guide
All panels remaining in the machine (in-conveyor, in-carrier, XY-table) can be
unloaded. Remove the panels in order as they are unloaded to the out-con-
veyor.
Procedure
1. Select [Panel Loader] from the [Setup] section at the [Main]
screen.
2. Select [Flush Out] from the [Load/Unload] section.
3. Press the START button.
The position from which the XY-table receives a panel from the in-conveyor
is referred to as the "loading position" and the position from which a panel is
unloaded from the XY-table to the out-conveyor is called the "unloading posi-
tion".
Procedure
1.
Select [Panel Loader] from the [Setup] section at the [Main]
screen.
2. Select [Move to Loading Position] or [Move to Unloading
Position] from the [Main Conveyor] section.
3. Press the START button.
8.6 Moving to the Panel Loading/
Unloading Position on the XY-Table
8.5 Unloading All Panels
Chapter 8: Production Support Functions
Preliminary
8-5CP-842E/842ME Operator’s Guide