TUT-CP842-Oper guide-preliminary.pdf.pdf - 第39页

Setting the Scheduled Production Quantity Specify the number of panels that are scheduled to be produced using the production program currently selected for use. The machine stops when the scheduled production quantity h…

Changing the Production Program

Follow the procedure below to change the production program.

Note: Refer to the host computer operation manual for the procedure on how to

transmit production programs.

Procedure

1. Select [Program] from the [Main] screen.

2. Select the production program that is to be used in production

from the list of production program that display.

Note: Production Programs are stored on the hard disk in the machine. The

number of production programs that can be stored on the hard disk will

vary depending on the amount of available disk space. A list of all

production programs stored on the machine can be displayed by scrolling

down in the view window.

3. Press [OK] in the verification dialog box.

4. Press [Close] to return to the [Main] menu screen.

3.2 Production Programs

Chapter 3: Preparing for Production

Preliminary

3-8 CP-842E/842ME Operator’s Guide

Setting the Scheduled Production Quantity

Specify the number of panels that are scheduled to be produced using the

production program currently selected for use. The machine stops when the

scheduled production quantity has been produced.

Procedure

1. Select [Program] from the [Main] screen.

2. Press [Chg Scheduled Panels].

3. Input the scheduled production quantity using the numeric

keypad that appears.

4. Press [OK].

5. The numeric keypad will then disappear from the screen and the

scheduled production quantity that has been specified will be

enabled.

6. Press [Close] to return to the [Main] screen.

Note: If the scheduled production quantity is set to "0". Production continuous

indefinitely. The machine will continue to produce panels until the

operator quits production.

Chapter 3: Preparing for Production

Preliminary

3-9CP-842E/842ME Operator’s Guide

Setting the Device Table Mode

Select the method in which the device tables are to be used (Table mode) in

accordance with production.

Joint mode:

The device tables D1 and D2 are operated together as a single device table.

This mode is used for production programs that have a large number of parts.

Joint resupply mode:

Joint resupply mode is basically the same as the standard joint mode in that

both tables are used in production. However, in joint resupply mode, the table

which is inactive in moved to the retract position until required, and feeders

can be set or removed at this position without interrupting production.

Device Change mode:

One of the device tables D1 or D2 is used in production while the other table

is kept in the standby position for use as a reserve. When a part runs out on

the device table in use, a switch is made to the other device table and

production continues. The relevant device slots on each table must be loaded

with the same parts.

Changeover mode:

One of the device tables D1 or D2 is used for production while parts are

switched on the other to ready it for the next production run.

Note: When either the “Device Change Mode” or the “Changeover Mode” is

selected, the [Original Table] setting described below must also be

specified.

Procedure

1. Select [Operation] from the [Main] screen.

2. Select the table mode that is to be used in production. Select

either "Joint", "Device Change", or "Changeover".

3. Press [Close] to return to the [Main] screen.

3.3 Device Tables

Chapter 3: Preparing for Production

Preliminary

3-10 CP-842E/842ME Operator’s Guide