00196284_Install_WinXP_unattended_DVD.pdf - 第10页
Windows XP Unattended Setup DVD V4 .2 11/2015 Edition 10 4 Installa tion Note: During th e setup you can nav igate the d ialogs w ith Next or Back b uttons. 4.1 Installation Hardware specific requirements and restriction…
Windows XP Unattended Setup DVD V4.2 11/2015 Edition
9
- Subnet mask
- Default gateway (Optional, if no Remote Support was installed no entry.
Default: no entry)
6
Custom Hosts- File entries as required - especially machine controller and line computer entries.
7
Used touch screen type
3.2.3 Vision Computer settings
5
IP configuration of each network adapter, especially the connection(s) to the stations.
- IP address
- Subnet mask
- Default gateway (Optional, if no Remote Support was installed no entry.
Default: no entry)
6
Custom Hosts- File entries, if required
3.2.4 Line Computer settings
5
IP configuration of each network adapter, especially the connection(s) to the stations and other
SIPLACE computers.
- IP address
- Subnet mask
- Default gateway (Optional, if no Remote Support was installed no entry.
Default: no entry)
6
Custom Hosts- File entries, if required
Windows XP Unattended Setup DVD V4.2 11/2015 Edition
10
4 Installation
Note:
During the setup you can navigate the dialogs with Next or Back buttons.
4.1 Installation Hardware specific requirements and restrictions
4.1.1 SIMATIC Box PC 627
→ Ensure you have the appropriate BIOS version and the corresponding settings, delivered on CDs. The
minimum BIOS version is V05.01.09.
→ Ensure the BIOS setting “Installed O/S” is set to “WinXP/2000” and “SATA Controller Mode” is set to
“Compatible” for the operating system installation
→ To avoid crashes, ensure your USB Hub is connected to Port 0, as shown in the following picture.
4.1.2 SIMATIC BoxPC 827B
You have to ensure you connect the USB devices on the correct ports. Otherwise the install routine will be
held on the point “Installing Windows”.
The USB devices must be plugged into the BoxPC 827B in the right position. The touch screens on the left
USB ports, the keyboards on the right ports.
See the following picture.
Port 0
Windows XP Unattended Setup DVD V4.2 11/2015 Edition
11
4.1.3 Esprimo E 900
The Esprimo E 900 has ports as shown in the following picture.
Legend:
1: Power connectors (PC + Display)
2: USB 2.0 ports
3: PS/2 connectors for keyboard (purple) and mouse (green)
4: Display connector (DVI).
Note:
If you need to connect VGA displays, you have to use the delivered adapter as shown in the
picture above.
5: Onboard Serial port
6: Onboard LAN for SIPLACE LAN.
Note:
By default, this computer has only one LAN port. If you require an additional LAN port, you have
to insert an additional extension card.
7: USB 3.0 port
8: Port for delivered Serial Y- cable allowing connecting two additional serial devices
1
2
3
4
5
6
7
8