Horizon UserManualV6.pdf - 第214页

AUTOFLEX TOOLING Selecting this diagnostics module opens the following window: The menu bar changes displaying the following: Run Diagnost Next Previous Exit Next / Previous keys move the highlight bar up and down the li…

MULTI INTERFACE UNIT

Selecting this diagnostics module opens the following window:

The menu bar changes to the following:

Toggle Next Previous Exit

Next / Previous keys move the highlight bar up and down the list of selectable

diagnostic functions.

Toggle activates the diagnostic function, as selected by the highlight bar.

Exit returns operation to the module diagnostics page.

NOTE

This diagnostic can only be run when the machine is connected to an upline and

downline machine.

Toggle Available A This diagnostic function is currently not used.

Toggle Upline A Selecting this diagnostic function sends a request to the upline machine to send a

board.

Toggle Downline A Selecting this diagnostic function sends a request to the downline machine to

receive a board.

Machine Available AThis diagnostic function is currently not used.

Downline Ready A This diagnostic function continuously displays whether the downline machine is

ready to receive a board.

Upline Ready A This diagnostic function continuously displays whether the upline machine is

ready to send a board.

Software Version 6 User Manual 5.31

DIAGNOSTICS

MULTI INTERFACE UNIT

MIU D

agnost

CLEAR

SET

CLEAR

OFF

Machine Available A

Downline Ready A

Upline Ready A

Toggle

Available A

Upline A

Downline A

AUTOFLEX TOOLING

Selecting this diagnostics module opens the following window:

The menu bar changes displaying the following:

Run

Diagnost

Next Previous Exit

Next / Previous keys move the highlight bar up and down the list of selectable

diagnostic functions.

Run Diagnost activates the diagnostic function, as selected by the highlight bar.

Exit returns operation to the module diagnostics page.

Tooling Pins Selecting this diagnostic function alternately lifts and lowers all the pins,

continuously displaying the current status.

Clamp Enable Selecting this diagnostic function alternately switches the electromagnet clamps

on or off, continuously displaying the current status. Any pins that are up when

the clamp is switched off automatically lower.

Clamp Power Selecting this diagnostic function alternately switches the power through the

electromagnetic coils between high and low, continuously displaying the current

status.

5.32 User Manual Software Version 6

DIAGNOSTICS

AUTOFLEX TOOLING

Autof

ex D

agnost

Down

Tooling Pins

Clamp Enable

Clamp Power

Change Pin Status

Cycle Autoflex Tooling

Change Pin Status Selecting this diagnostic function enables different pin patterns to be exercised.

On selection the following window opens:

The menu bar changes to the following:

Lower Raise Set

Status

Left Right Up Down Exit

Left, Right, Up and Down keys move the cursor to enable individual pins to be

selected.

Lower or Raise keys enable the selected pin to be raised or lowered.

Set Status key enables the AutoFlex to set the selected pin pattern. The message

Setting Up AutoFlex Tooling is displayed in the message window.

Exit returns operation to the AutoFlex diagnostics page.

Cycle AutoFlex

Tooling

Selecting this diagnostic function cycles the AutoFlex pins in a set pattern. The

pattern is as follows:

1. All the pins are raised.

2. The pins are lowered leaving a third raised, every third pin.

3. All the pins are raised.

4. The pins are lowered leaving a second third raised.

5. All the pins are raised.

6. The pins are lowered leaving the last third raised.

7. The process repeats until the Stop key is pressed.

Software Version 6 User Manual 5.33

DIAGNOSTICS

AUTOFLEX TOOLING

Autof

ex Matr

---------------