Horizon UserManualV6.pdf - 第375页
10. Press the System button. During a Print Run When the transfer head needs replenishing a warning window is automatically displayed on the monitor. The warning window varies, depending on the setting of the consumable …
4. Fill the diaphragm until it starts to balloon, this can be spread sideways by
massaging the diaphragm with the fingers.
5. Alternatively, fill using all three filling ports for even distribution.
NOTE
Ensure that only one port is opened at a time.
6. Do not overfill. If this occurs any excess will seep out between the wipers
and the screen.
NOTE
Clean any excess seepage before commencing print operations.
7. Ensure that the threaded areas around the filling ports are thoroughly clean
before commencing print operation.
8. Refit the port bayonet caps.
9. Close the front printhead cover.
9.74 User Manual Software Version 6
CONSUMABLE REPLENISHMENTS
PROFLOW
Short Recharging Nozzle
10. Press the System button.
During a Print Run When the transfer head needs replenishing a warning window is automatically
displayed on the monitor. The warning window varies, depending on the setting
of the consumable action in set preference.
If the set preference is set to warn, continue with Step 1. If the set preference is
set to pause go to Step 6. If the set preference is set to suspend go to Step 13.
1. If the set preference is set to warn, the following window is displayed:
The tricoloured beacon shows amber/green.
2. Select Confirm (F1).
Confirm
3. Select End Run (F1), when the ProFlow unit is at the rear of the image.
End
Run
Stop
Cycle
Paste
Load
Clean
Screen
Adjust Knead
Paste
4. Carry out Steps 19-29 of Prior to a Print Run procedure, earlier in this
section.
5. Select Run (F1). The print run resumes.
Run
Open
Cover
Knead
Paste
Clean
Screen
Adjust Setup Monitor Maint.
Software Version 6 User Manual 9.75
CONSUMABLE REPLENISHMENTS
PROFLOW
6. If the set preference is set to pause, the following window is displayed:
The tricoloured beacon shows red.
7. Select Refill Paste (F1).
Refill
Paste
Defer
The message ‘Open the cover and change the ProFlow cassette.’ is
displayed.
8. Select Open Cover (F2).
Continue
Open
Cover
9. Carry out Steps 19-29 of Prior to a Print Run procedure, earlier in this
section.
10. Select Continue (F1). The print run resumes.
Continue
Open
Cover
11. If the set preference is set to suspend, the following window is displayed:
The tricoloured beacon shows red.
12. Select Refill Paste (F1).
Refill
Paste
Defer
The message ‘Open the cover and change the ProFlow cassette.’ is
displayed.
9.76 User Manual Software Version 6
CONSUMABLE REPLENISHMENTS
PROFLOW