Horizon UserManualV6.pdf - 第348页
10. Insert the screen into the printer, ensure correct orientation and print justification. 11. Close the front printhead cover. 12. Press the System button. 13. Press Change Screen (F2). Change Screen Board Clamps Prime…
7. Fit the edge of the new cleaning cassette (1) beneath the solvent bar (3) and
snap into place on the two pip pins (2).
NOTE
Numbers in brackets refer to figure below.
8. Press Prime Solvent (F6) key.
Screen
Clamps
Board
Clamps
Prime
Solvent
Exit
The message ‘Press the two button control buttons to prime solvent.’ is
displayed.
9. Prime the solvent using the two button control.
Software Version 6 User Manual 9.47
CONSUMABLE REPLENISHMENTS
VORTEX UNDERSCREEN CLEANER
1
2
2
3
10. Insert the screen into the printer, ensure correct orientation and print
justification.
11. Close the front printhead cover.
12. Press the System button.
13. Press Change Screen (F2).
Change
Screen
Board
Clamps
Prime
Paper
Prime
Solvent
Exit
14. Press Exit (F8).
Change
Screen
Board
Clamps
Prime
Paper
Prime
Solvent
Exit
9.48 User Manual Software Version 6
CONSUMABLE REPLENISHMENTS
VORTEX UNDERSCREEN CLEANER
SQUEEGEES
Fitting the
Squeegees
From the Status page:
1. Press Setup (F6).
Run Open
Cover
Paste
Load
Clean
Screen
Adjust
Setup
Monitor Maint.
2. Press Setup Squeegee (F4).
Mode Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit
3. Press Change Squeegee (F1).
Change
Squeegee
Calibrat
Heights
Exit
The message ‘Open cover and change squeegees’ is displayed.
4. Open the front printhead cover.
The front and rear squeegees must be fitted in the correct positions. Each
squeegee has a key-way machined into it to ensure that it cannot be incorrectly
fitted.
Software Version 6 User Manual 9.49
CONSUMABLE REPLENISHMENTS
SQUEEGEES