Horizon UserManualV6.pdf - 第334页
19. Insert the screen into the printer, ensure correct orientation and print justification. 20. Close the front printhead cover. 21. Press the System button. 26. Press Change Screen (F2). Change Screen Board Clamps Prime…
16. Ensure the cleaner paper has been routed correctly, from underneath the
paper roll (1) rearwards across the squeegee assembly and threaded between
paper rod and shaft (2).
NOTE
Figures in brackets refer to the diagram below.
17. Press Prime Paper (F5) key.
Board
Clamps
Prime
Paper
Prime
Solvent
Exit
The message ‘Press the two control buttons to feed paper’ is displayed.
18. Using the two button control, prime the paper ensuring it feeds correctly.
Software Version 6 User Manual 9.33
CONSUMABLE REPLENISHMENTS
BLUE UNDERSCREEN CLEANER
1
2
19. Insert the screen into the printer, ensure correct orientation and print
justification.
20. Close the front printhead cover.
21. Press the System button.
26. Press Change Screen (F2).
Change
Screen
Board
Clamps
Prime
Paper
Prime
Solvent
Exit
24. Press Exit (F8).
Change
Screen
Board
Clamps
Prime
Paper
Prime
Solvent
Exit
9.34 User Manual Software Version 6
CONSUMABLE REPLENISHMENTS
BLUE UNDERSCREEN CLEANER
VORTEX UNDERSCREEN CLEANER
Provision is made on the printer for automatic underscreen cleaning. This is
carried out using a cleaning cassette which contains a wet and a dry cell. The wet
cell is impregnated with an appropriate solvent. A cleaning cycle consists of a
single return stroke incorporating a wet and dry wipe with or without vacuum.
The cleaning options can be programmed into a particular product file so that
they take place at preprogrammed intervals or they can be selected, directly from
the MMI, to take place at the operators discretion.
Programming
Screen Clean
Operation into a
Product File
The screen clean parameters can be setup when editing a product file, while
setting up a new product. It may be more convenient to set these after the
product has been setup and printed and screen cleaning requirements have been
decided upon.
The parameters to be edited that affect the operation of the underscreen cleaner
are listed below with a definition of each as an aid to setup:
Parameter Definition
Front Start Offset The distance, in from the front edge of the board, at which the cleaner is to
finish. While a Vortex USC is in use the minimum value is extended from 0
to -60mm.
Minimum -60mm
Maximum 60mm
Default 30mm
Increment 1mm
Rear Start Offset The distance, in from the rear edge of the board, at which the cleaner is to
start. While a Vortex USC is in use the minimum value is extended from 0 to
-60mm.
Minimum -60mm
Maximum 60mm
Default 30mm
Increment 1mm
Software Version 6 User Manual 9.35
CONSUMABLE REPLENISHMENTS
VORTEX UNDERSCREEN CLEANER