Horizon UserManualV6.pdf - 第327页
4. Press the System button. 5. Press Prime Solvent (F6) key. Change Screen Board Clamps Prime Paper Prime Solvent Exit The message ‘Press the two button control buttons to prime solvent.’ is displayed. 6. Prime the solve…
1. Remove the solvent tank cap (1) from the solvent tank (2).
NOTE
Numbers in brackets refer to figure below.
2. Using a suitable container refill the tank and replace the cap.
3. Close the front printhead cover.
9.26 User Manual Software Version 6
CONSUMABLE REPLENISHMENTS
BLUE UNDERSCREEN CLEANER
1
2
WARNING
SOLVENT SOLUTION. DO NOT MIX SOLVENT SOLUTIONS. FLUSH
THE SOLVENT TANK THOROUGHLY WHEN CHANGING TO
A
DIFFERENT SOLVENT SOLUTION.
WARNING
SOLVENT SPRAY. THE UNDERSCREEN CLEANER SPRAYS A FINE
JET OF SOLVENT SOLUTION ON TO THE CLEANER. APPROVED
PROTECTIVE CLOTHINGSHOULD BE WORN.
WARNING
PROTECTIVE CLOTHING. APPROVED PROTECTIVE CLOTHIN
G
SHOULD BE WORN BY SOLDER PASTE AND SOLVENT HANDLERS
AT ALL TIMES TO ELIMINATE FUME INHALATION, EYE
CONTACT, SKIN CONTACTAND INGESTION.
4. Press the System button.
5. Press Prime Solvent (F6) key.
Change
Screen
Board
Clamps
Prime
Paper
Prime
Solvent
Exit
The message ‘Press the two button control buttons to prime solvent.’ is
displayed.
6. Prime the solvent using the two button control.
7. Press Exit (F8).
Change
Screen
Board
Clamps
Prime
Paper
Prime
Solvent
Exit
Paper
Replenishment
NOTE
When using 300 or 400mm wide paper rolls, ensure the correct paper roll
spacers are used.
Software Version 6 User Manual 9.27
CONSUMABLE REPLENISHMENTS
BLUE UNDERSCREEN CLEANER
WARNING
PROTECTIVE CLOTHING. APPROVED PROTECTIVE CLOTHIN
G
SHOULD BE WORN BY SOLDER PASTE AND SOLVENT HANDLERS
AT ALL TIMES TO ELIMINATE FUME INHALATION, EYE
CONTACT, SKIN CONTACTAND INGESTION.
WARNING
FLAMMABLE. THE USED PAPER ROLL CONTAINS RESIDUES O
F
UNDERSCREEN CLEANER FLUID AND SOLDER PASTE. OBSERVE
MANUFACTURERS' RECOMMENDED DISPOSALINSTRUCTIONS.
1. Lift the empty paper roll from the front of the cleaner.
2. Remove the paper spindles from both ends of the empty paper roll.
3. Remove the take up roll from the rear of the unit by easing the roll to the left
against spring pressure, until the right hand end is clear of the motor drive
spindle in the right hand end plate. Lift the take up roll clear of the unit.
9.28 User Manual Software Version 6
CONSUMABLE REPLENISHMENTS
BLUE UNDERSCREEN CLEANER