00198243-01_AI_BulkFeederX_XS-SX_DE+EN.pdf - 第111页

4 Retrofit kit for X-Series S 4.1 Preparatory steps on the X-Series S Assembly Instructions / Montageanleitung SIPLACE BulkFeeder X Retrofit Kit for SX Series and X Series S 07/2017 111 4 Retrofit kit for X-Series S 4.1 …

3 Retrofit kit for SX-Series

3.5 Connecting the cable

110 Assembly Instructions / Montageanleitung SIPLACE BulkFeeder X Retrofit Kit for SX Series and X Series S 07/2017

Connecting the BulkFeeder X

One BulkFeeder X can be connected and operated per location. It can be placed anywhere on the

changeover table.

► Run the connection cable under the tapes.

► Connect the cable (1).

NOTICE

Non-initialization of BulkFeeder X

If the BulkFeeder X is not initialized at location 1, place the cable in the box with the pneu-

matic unit (2) for safety reasons.

4 Retrofit kit for X-Series S

4.1 Preparatory steps on the X-Series S

Assembly Instructions / Montageanleitung SIPLACE BulkFeeder X Retrofit Kit for SX Series and X Series S 07/2017 111

4 Retrofit kit for X-Series S

4.1 Preparatory steps on the X-Series S

► Move all component trolleys out of the machine.

► Switch off the machine, disconnect it from the

power supply and secure it to prevent

unauthorized reactivation. Observe the instruc-

tions in section 1.2 "Preparatory Work..." [}84].

► Remove all waste tape slides and covers from

the bottom of the machine.

4.2 Preparatory steps

To operate the machine with a BulkFeeder X, you must retrofit both existing station computer and

the new Box PC, which is used as the BulkFeeder X computer, with different PCI cards.

●

Installation of a GigE card in the BulkFeeder X computer, to connect the BulkFeeder X.

●

X-Series S from serial number H0001: Installation of a LAN card in the station computer of the

machine, to connect the station computer to the BulkFeeder X computer.

4.2.1 Installation of a GigE card in the BulkFeeder X computer

To fit the GigE card [03135985-xx] in the BulkFeeder X computer, proceed as follows:

► Release the two locks on the plastic cover (1)

and remove these.

4 Retrofit kit for X-Series S

4.2 Preparatory steps

112 Assembly Instructions / Montageanleitung SIPLACE BulkFeeder X Retrofit Kit for SX Series and X Series S 07/2017

► Remove the screws (1) on the housing cover.

► Swing open the housing cover; it is held on the

folding edge by two hinges.

► Open the cover and lift it off the hinges.

► Place the cover to one side.

► Remove the screw (1) fastening the lower pro-

tective cover (2).

► Pull the protective cover off its fixtures.

► Keep the fastening screw (1). The protective

cover (2) is no longer needed.