00198243-01_AI_BulkFeederX_XS-SX_DE+EN.pdf - 第115页

4 Retrofit kit for X-Series S 4.3 Fitting the BulkFeeder X computer Assembly Instructions / Montageanleitung SIPLACE BulkFeeder X Retrofit Kit for SX Series and X Series S 07/2017 115 4.3 Fitting the BulkFeeder X compute…

100%1 / 148
4 Retrofit kit for X-Series S
4.2 Preparatory steps
114 Assembly Instructions / Montageanleitung SIPLACE BulkFeeder X Retrofit Kit for SX Series and X Series S 07/2017
► The retrofitted computer is now ready. There are
four LAN ports for connection of the BulkFeeder
X LAN cable.
► Connection of the cable is described in the cable
instructions and in section 4.6 "Connecting the
cable" [}128].
► At the side, fit the Profibus (1) for strain relief and
the cable guidance with fastening screws (2).
► Position the two book holders (1) onto the Bulk-
Feeder X computer (2) and fasten these with the
screws provided (3) to the rear side. This allows
you to fit the BulkFeeder X computer later into
the additional holder, next to the pneumatic unit
at location 4.
4 Retrofit kit for X-Series S
4.3 Fitting the BulkFeeder X computer
Assembly Instructions / Montageanleitung SIPLACE BulkFeeder X Retrofit Kit for SX Series and X Series S 07/2017 115
4.3 Fitting the BulkFeeder X computer
NOTICE
Number of persons for assembly
If possible, 2 people should be available for the assembly.
The BulkFeeder X computer is fitted behind the corner cover at location 4, under the pneumatic
unit.
4.3.1 Dismantling the lower side cover
To fit the BulkFeeder X computer at location 4, you need to remove the side cover. To do so, pro-
ceed as follows:
► Loosen the six screws(1) fastening the inside(A)
and outside(B) of the side cover and remove the
side cover. While unscrewing, always hold on to
the side cover, to prevent it falling off.
 NOTICE!
The three fastening screws (2) on the outer
side are just loosened. The side cover can be
pulled out here.
.
4.3.2 Fitting the Bulkfeeder X computer
To fit the BulkFeeder X computer behind the corner cover at location 4, you need to fit an additional
holder next to the pneumatic unit. To do so, proceed as follows:
► Remove the top screw (1) for the pneumatic unit.
► Insert the longer screw M6x20 through the open-
ing. Rotate is about twice so that it holds the unit.
► Remove the bottom screw (2) for the pneumatic
unit. The pneumatic unit can now be moved.
4 Retrofit kit for X-Series S
4.3 Fitting the BulkFeeder X computer
116 Assembly Instructions / Montageanleitung SIPLACE BulkFeeder X Retrofit Kit for SX Series and X Series S 07/2017
► Insert the holder (1) into the inside. Make sure
that no hoses or cables are trapped.
► Position the holder. Tighten the bottom screw (1).