N7201A616E00_0317.pdf - 第139页

NPM-W 2 EJM7DE-MB-02 O-00 2-4-1 -4 Preparatio n Removing the thin type tape feeder 2 Remove it from the dedicated attachment 1 Pull out the feeder How to hold the feeder Hold the parts wi th both hands ● When the tape fe…

NPM-W2 EJM7DE-MB-02O-00

2-4-1-3

Prepara-

tions

before

produc-

tion

Operating procedure

2-4-1

Preparation of the

intelligent feeder 2

Removing the double tape feeder

Lift up the rear

side and remove

the feeder with

both hands

Pull up the lever

and pull out the

feeder

How to hold the feeder

Hold the parts with

both hands

Batch exchange using the feeder cart (option)

Pay attention to your surroundings when you move the feeder

cart

(Risk of injury in a collision with the cart )

WARNING

Setting up production feeders on the spare feeder cart in advance allows you to replace the feeders by one

operation during a changeover. (→[Maintenance] P.3-2)

NPM-W2 EJM7DE-MB-02O-00

2-4-1-4

Preparation

Removing the thin type tape feeder

Remove it from

the dedicated

attachment

Pull out the

feeder

How to hold the feeder

Hold the parts with

both hands

●When the tape feeder is removed during production, remove in such a way that you

push the tape edge down.

●Do not put the tape feeder back in the middle of removal. Doing so may cause the

machine to stop due to blocking the light of the feeder opening sensor by the tape edge.

NOTE

Lift it up at the

stopper position

and remove

Pull up the lever

and pull out the

attachment

This procedure is performed when using the thin type tape feeder.

■Removing the dedicated attachment

How to hold the feeder

Hold the parts with

both hands

■Removing the thin type tape feeder

NPM-W2 EJM7DE-MB-02O-00

2-4-1-5

Preparation of the

intelligent feeder 3

Attaching the separator to the feeder cart

(If the large reel is too heavy to operate smoothly)

Attach a spindle to the separator

Separator

Spindle

Screw

M4x8L

Attachment hole

For large reel

(2 locations)

●Choose an attachment hole

according to the reel size.

●Choose a spindle (accessory)

according to the mounting

pitch.

Attach the

separator to the

cart

Separator

Insert the top of the

upper side into the holder.

Separator

Fit the lower end through

the gap in the reel guide.

Attach it to sit on the

spacer.

Make sure that

the reel can

rotate

Separator

Operating procedure

2-4-1

Prepara-

tions

before

produc-

tion

Accessories

Part No.: N610119865AA

For 21 mm pitch (L: 19.2 mm)

Part no.: KXFB058WA00･･･2pcs

For 42 mm pitch (L: 40.2 mm)

Part no.: KXFB058XA00･･･2 pcs

For 63 mm pitch (L: 61.2 mm)

Part no.: KXFB058YA00･･･2 pcs

For 84 mm pitch (L: 82.2 mm)

Part no.: KXFB058ZA00･･･2 pcs