N7201A616E00_0317.pdf - 第442页
NPM-W 2 EJM7DE-MB-06O-0 0 6-2-2 -7 Produc- tion data teaching PCB r ecognition teac h 4 Operating procedure 6-2-2 This is us ed when the sh ape of a recognition targ et (mark ) is too comp lex to be sharply d efined, or …
NPM-W2 EJM7DE-MB-06O-00
16
6-2-2-6
16
17
+
Confirm the message
17
●You may transition to the other
screen.
■To reconfirm the data
15
15
(The measurement result of the
recognition mark is displayed again)
■When the PCB is not unloaded
+
Setting
change
NPM-W2 EJM7DE-MB-06O-00
6-2-2-7
Produc-
tion data
teaching
PCB recognition teach
4
Operating procedure
6-2-2
This is used when the shape of a recognition target (mark) is too complex to be sharply defined, or when a
recognition target is too large to fit in the recognition screen.
Note that, when using this function, you should set the shape type of PCB recognition marks for 1 point block
on DGS. You can check on the PCB recognition data screen or the PCB recognition teach screen to see
whether it has been set for 1 point block.
Display the <Main menu> screen in advance, and send PCB data used to change production PCBs from
NPM-DGS.
Put a PCB at the PCB loading
entrance
1
2
Close the safety cover
3
(The PCB is loaded and clamped at the
unloading position. The head camera
moves to the recognition mark position.)
4
4
Make a fine adjustment or
inching of the mark so that it is
centrally-located
5
A
Adjust the lamp value so that the mark
Can be seen clearly.
A
Block match 1
Servo switch ON
+
NPM-W2 EJM7DE-MB-06O-00
6-2-2-8
Setting
change
B
C
D
6
7
8
9
7
8
9
C
Move or resize the window so that the
mark comes to the center of the teach
target.
D
Set an area of an image used for block
match recognition.
B
Move or resize the window so that the
mark comes to the center of the teach
target.
6