N7201A616E00_0317.pdf - 第708页
NPM-W 2 EJM7DE-MB-09O -00 9-1-10 -3 Specifi- cation Placement mode 2 Operating procedure 9-1-10 Line ■ Non-stop changeover line ● You can keep produ cing in one lane while co nducting a changeover in the other lan e. (In…
NPM-W2 EJM7DE-MB-09O-00
9-1-10-2
■Large size PCB mounting line
●Minimizes board transport losses.
●Realizes highly efficient production
through the smallest number of feeder
locations.
■High-efficiency mounting line
●Specifically designed for large size
boards that can not make use of dual
transport.
●Realizes the fastest placement of PCBs
of a pattern at the fastest rate.
The combination of placement modes allows NPM-W2 to respond to the needs of your various
production patterns.
Line
alternative mode
alternative mode (Single lane)
■Fastest mounting line
Independent mode
At
a glance
NPM-W2 EJM7DE-MB-09O-00
9-1-10-3
Specifi-
cation
Placement mode 2
Operating procedure
9-1-10
Line
■Non-stop changeover line
●You can keep producing in one lane
while conducting a changeover in the
other lane. (Independent changeover)
Independent mode
Independent mode plus Alternative mode (front/rear)
Independent mode
Alternative mode (front/rear)
NPM-W2 EJM7DE-MB-09O-00
9-1-10-4
■High-speed/High-efficiency mounting line
Independent mode plus Alternative mode
Independent mode Alternative mode
●Line configuration that utilizes the merits
of Independent and Alternate modes.
●Chip parts can be mounted faster, and
atypical or tray components, more
efficiently.
■Imbalanced mounting line
Independent mode plus Alternative mode (front)
Independent mode Alternative mode (front)
●You may configure the mounting line
shown in the left figure if unable to
achieve a production balance between
the front and rear sides.
e.g.)
Board A :
300 placement points (chip parts only)
Board B :
600 placement points (chip parts plus
atypical components)
At
a glance