N7201A616E00_0317.pdf - 第707页

NPM-W 2 EJM7DE-MB-09O -00 9-1-10 -2 ■ Large size PCB mounting line ● Minimizes board transpo rt losses. ● Realizes highly efficient produc tion through the smallest numbe r of feeder locations. ■ High-efficiency mounting…

100%1 / 714
NPM-W2 EJM7DE-MB-09O-00
9-1-10-1
Specifi-
cation
Placement mode 1
Operating procedure
9-1-10
Feature
■Alternate mode
●The head moves
alternatively and performs
production.
●Each head produces PCB
on the front and rear lane.
●The head moves
alternatively and after
production of the target
lane completes, it
produces PCB on the other
lane.
■Alternate front (rear) mode
*1）
■Independent mode
*1）
●Using the front and rear heads,
only PCBs on the front (rear) lane
are produced, and PCBs on the
rear (front) lane are passed through.
●Each head independently
carries out production for
PCBs on each head.
Front head: Front lane
production
Rear head: Rear lane
production
●It minimizes the PCB
transfer loss.
●Production start and stop are
applicable per lane.
●Production start and stop
is applicable per lane.
●It improves productivity
because the head does not
need to wait for head
alternative motion (waiting
for motion of the other
head.
*2）
Changeover
●You need to stop the
machine to carry out
changeover for each lane.
●Changeover (changing the
production data or the feeder cart
*3）
,
or replacing the tray magazine) is
applicable for the suspended lane
while PCBs are passed through.
●Changeover (changing the
production data or replacing
the feeder cart
*3）
or the
tray magazine) is applicable
for the suspended lane
during one-side production.
*1)Independent mode and alternative (front / rear) mode are applicable for placement head specification.
*2)Head standby may arise depending on the PCB size.
*3) When changeover support unit is selected(→P.9-1-13)
Machine body
In dual lane mode, alternative mode and independent mode are available depending on the created data.
■Precautions
1. Any lane that the production data is not selected is not perform production.
2. Data creation and configuration of the placement mode are conducted on NPM-DGS.
For details, see the NPM-DGS instruction manual.
NPM-W2 EJM7DE-MB-09O-00
9-1-10-2
■Large size PCB mounting line
●Minimizes board transport losses.
●Realizes highly efficient production
through the smallest number of feeder
locations.
■High-efficiency mounting line
●Specifically designed for large size
boards that can not make use of dual
transport.
●Realizes the fastest placement of PCBs
of a pattern at the fastest rate.
The combination of placement modes allows NPM-W2 to respond to the needs of your various
production patterns.
Line
alternative mode
alternative mode (Single lane)
■Fastest mounting line
Independent mode
At
a glance
NPM-W2 EJM7DE-MB-09O-00
9-1-10-3
Specifi-
cation
Placement mode 2
Operating procedure
9-1-10
Line
■Non-stop changeover line
●You can keep producing in one lane
while conducting a changeover in the
other lane. (Independent changeover)
Independent mode
Independent mode plus Alternative mode (front/rear)
Independent mode
Alternative mode (front/rear)