N7201A616E00_0317.pdf - 第593页

NPM-W 2 EJM7DE-MB-07 O-00 ■ If air blow and the vacuum pressure measurement r esults in er ror Confirm the message (The backgroun d of the measured value of the c orresponding noz zle is displayed in yellow.) 7-2-6 -2 + …

100%1 / 714
NPM-W2 EJM7DE-MB-07O-00
■If vacuum check has completed successfully
[Check vacuum complete] is displayed in .
■If vacuum check failed to complete
successfully
The background of the measured value of the
corresponding nozzle is displayed in yellow.
Unit
adjust-
ment
Action check of the
placement head
7-2-6-1
You can collectively check whether the actions of the placement head or nozzles are normal.
●Perform on both and .
Operating procedure
7-2-6
1
+
A B
C D
A
B
C
F
E
F
2
1
D
E
F
(The vacuum check result of each nozzle
is displayed)
Nozzle
A number of a nozzle attached to the
placement head.
●”-” is displayed if any nozzle is not
attached.
Sensor value
●If the measured value is abnormal, its
background is shown in yellow.
Full
●Filter clogging detection value. Check
if the measured value is abnormal as
the result of [Filter cleaning].
The previous or next table
is displayed.
Err.
●Nozzle clogging detection value.
Check if the measured value is
abnormal as the result of [Vacuum
check].
Message display area
NPM-W2 EJM7DE-MB-07O-00
■If air blow and the vacuum pressure
measurement results in error
Confirm the message
(The background of the measured value
of the corresponding nozzle is
displayed in yellow.)
7-2-6-2
+
2
(Air blow and the vacuum pressure of
each head (nozzles are removed) are
measured)
System
administration
■If air blow and vacuum pressure
measurement completes without error
[Cleaning blow complete] is displayed
in .
F
NPM-W2 EJM7DE-MB-07O-00
Unit
adjust-
ment
Vacuum output check
(placement head)
7-2-7
1
You can change the valve and check whether each of the vacuum pumps and air blows operates normal
individually.
+
1
+
+
+
BA C
A
B
C
BC
Operating procedure
7-2-7
Air flow value
Nozzle air flow value.
Check the air flow value during
vacuuming or blowing
■To turn ON/OFF the vacuum pump
(The vacuum pump is switched ON/OFF)
■With the vacuum pump turned ON, to
turn ON/OFF only the vacuum valve
of a specified nozzle
(The vacuum pressure is displayed in the
field below)
■With the vacuum pump turned ON,
to turn ON/OFF only the vacuum
break valve of a specified nozzle
(The pressure for the vacuum break is
displayed in the field above)
■To turn ON/OFF the cleaning blow
(The cleaning blow valve is switched
ON/Off)
Vacuum valve
Vacuum break valve
● , in 7-2-6 is displayed in
terms of 8-bit.
B
B
C
：“Sensor value” ：“Full”
●Perform on both and .