APPENDIX.pdf - 第62页

Samsung Component Placer CP-45F(V)/FS Operations Manual C-4 C.4. Setting the use of Shuttle T r ay Feeder Figur e C-4. "Feeders" dialog box The method of setting the Feeder to supply components by using the Shu…

Appendix C Shuttle Tray Feeder

C-3

C.3. Registering Components Supplied to Shuttle Tray Feeder

Figure C-3. "Create a new part/Edit the selected part" dialog box

The method of registering components supplied to the Shuttle Tray is the same as that for

the registration of existing components.

That is, as can be seen in Figure C-3, specify the Feeder item to ‘FW-20CS (Shuttle)’ in

the "Create a new part/Edit the selected part" dialog box (PCB EditPartNew Part…).

Samsung Component Placer CP-45F(V)/FS Operations Manual

C-4

C.4. Setting the use of Shuttle Tray Feeder

Figure C-4. "Feeders" dialog box

The method of setting the Feeder to supply components by using the Shuttle Tray is the

same as that for the existing Tray Feeder. However, as can be seen in the "Feeders" dialog

box (PEB EditFeederTray Unit) in Figure C-4, the menu items of Tray Feeder are

changed or the following items are added.

 Shuttle Pick

When there is a component in the Shuttle, it is picked up. If not, a component is

supplied from the Shuttle Tray and it is picked up.

 Shuttle Supply

Receives a component from the Shuttle Tray and moves it to the component supply

position in the CP45 equipment.

 CS Pocket Move

Moves the head of the Shuttle Tray to the designated Palette and the position of

Pocket in the Shuttle Tray.

 Using the Dump Conveyor

When the Shuttle Tray is used, the existing ‘Return to Tray’ Dump can not be used.

Accordingly, when the Dump Conveyor is used, ‘Dump Conveyor’ is set as the

default Dump position. For the registration of 'Dump Conveyor', please refer to C.5

Precautions for the use of Shuttle Tray Feeder (page C-5 ).

Appendix C Shuttle Tray Feeder

C-5

C.5. Precautions for the use of Shuttle Tray Feeder

C.5.1. Board Size limit

When using the Shuttle Tray Feeder, the length (Y direction of CP45 equipment) of

applicable PCB board is limited to under 300mm.

C.5.2. Using Dump Conveyor

When using the Shuttle Tray Feeder, 'Return to Tray' can not be used for the Dump Box

unlike regular Tray Feeders. Instead, the Dump Conveyor can be used. The Dump

Conveyor can be registered in the "Dump Box" dialog box (Sys. SetupTray) as in

Figure C-5, and the procedure is as follows.

① Enter the location where the Dump Conveyor is installed.

② Set whether the Dump Conveyor is to be used or not.

③ Enter the Feeder lane that is occupied by the Dump Conveyor.

Figure C-5. "Dump Box " dialog box

C.5.3. Condition for Cycle creation

The number of components using the Shuttle Tray Feeder in one cycle can not be more

than 2(number of PADs).

C.5.4. Adding Shuttle Tray related function to ProductionT/F Cnt

In the case of Shuttle Tray Feeder, whether a component exists in the current Shuttle can