APPENDIX.pdf - 第69页
Appendix D. Docking Cart D-5 Figur e D-4. The cylinder down D.2.3. S/W Operation D.2.3.1. Software specifications Runs on MMI V ersion 2.108, VM E 2.3 or later versions. D.2.3.2. MMI System Setup Editing Select System Pr…
Samsung Component Placer CP-45F(V)/FS Operations Manual
D-4
8. Check if there is a problem with docking In/Out operation.
9. If needed , adjust the speed controller to have the desired speed since the more feeder
take the more time to keep the docking cart up and the less time to keep it down
3mm
11mm
6mm
TAPE FEEDER
ALIGN BODY
DC-FEEDER BASE
PIN
BUSH
LOW LIMIT
STOPPER
A+17mm
A
Figure D-2. Setting the height of the docking cart
Figure D-3. The cylinder up
Shaft
Nut
The bolt for locking shaft
Appendix D. Docking Cart
D-5
Figure D-4. The cylinder down
D.2.3. S/W Operation
D.2.3.1. Software specifications
Runs on MMI Version 2.108, VME 2.3 or later versions.
D.2.3.2. MMI System Setup Editing
Select System Preference from System Setup menu. Select Option tab on the System
Preference screen. And then you should set Feeder base system Option to Feeder
Base[Docking]. The numbers before each item indicate front feeder base(1) and rear
feeder base(2). (Referring to Figure E-5)
Samsung Component Placer CP-45F(V)/FS Operations Manual
D-6
Figure D-5. Setting the feeder base system option
D.3. Installation Method
D.3.1. Order of Changing the Docking Cart
To change the docking cart , perform the following steps.
1. Push the F/FEEDR Change switch on the front side of the machine to have the
machine be in ADJUST Mode. And then Make sure that the head move to the safety
zone.
2. Operate the mechanical valve to have the clamp cylinder released.
3. Connect the air hose to the docking cart and keep the valve up to raise the docking cart.
4. Separate the docking cart from the machine.
5. Change the feeders on the DC-Feeder Base.
6. Plug the docking cart into the machine completely and then push the stopper to lock
the docking cart.
The air hose closer to the check valve should be connected to the docking cart and then
you connect it to the machine. When the Docking Cart is installed on the machine, the
Docking In angle should be under 30°.
Caution