00198442-04_UM_TX-V2_EN.pdf - 第182页
4 Setting up and commissioning In struction manual SIPLACE TX 4.4 Infrastructure at the installation location From software ve rsion 714.0 12/2020 182 4.4 Infrastructure at the inst allation location 4 4.4.1 Recommendati…
Instruction manual SIPLACE TX 4 Setting up and commissioning
From software version 714.0 12/2020 4.3 Transporting the placement machine
181
4.3 Transporting the placement machine
The placement machine may only be lifted and transported with the fork-lift at the output side. The
diagram 4.2 - 4
, page 179 shows the fork-lift attachment points on the placement machine for lift-
ing the placement machine off the pallet or transporting it without the pallet.
4
4.3.1 Safety instructions during placement machine transportation
During transportation, always follow the safety instructions in section 4.1, page 171).
4
PLEASE NOTE
If the placement machine is at its place of final use and should be integrated into a line,
it may also be lifted to the actual locations with a pallet truck. See also section 4.5.5
, page
199)
.
4 Setting up and commissioning Instruction manual SIPLACE TX
4.4 Infrastructure at the installation location From software version 714.0 12/2020
182
4.4 Infrastructure at the installation location
4
4.4.1 Recommendations for foundation quality
The floor on which the placement machine is installed must be firm and level, as dynamic forces
could cause vibrations when the placement machine is operated. The degree of vibration depends
on the construction of the foundation. The following are suitable provided that the floor loading pa-
rameters, etc., are not exceeded:
– Reinforced concrete ceiling constructions, e.g. ceilings in production halls
– Reinforced concrete floor slabs, e.g. concrete floors in production halls without a basement
– Rooms with double floors, provided that a stable foundation is included in the space between
them. The same setup conditions apply to this intermediate foundation, which can be made
from steel girders or concrete.
4
4.4.1.1 Ground levelness
The floor underneath the placement machine may not exceed an incline of 0.63%. This corre-
sponds to an incline of 5 mm over a distance of 800 mm (e.g. the width of a changeover table).
4.4.1.2 Machine weight and floor surface load
The machine weight and floor surface load can be found in section 3.3.1, page 111.
PLEASE NOTE
Also observe the document "Network and compressed air configuration for SMD sys-
tems" (German+English, Item No. 00197548-xx), which is supplied with your SIPLACE
placement machine.
Instruction manual SIPLACE TX 4 Setting up and commissioning
From software version 714.0 12/2020 4.4 Infrastructure at the installation location
183
4.4.2 Compressed air supply
Fig. 4.4 - 1 Position of compressed air supply in the placement machine
(1) Installation position of compressed air supply at location 2
(T) Direction of travel
1